Instructions / Assembly

20
|
Bosch Climate 5000 AA Series Split Type Ductless Air Conditioner / Heat Pump Installation Manual
01.2017 | Bosch Thermotechnology Corp.Data subject to change
If you install the unit on a concrete mounting platform , do the following:
1. Mark the positions for four expansion bolts based on dimensions in the Unit
Mounting Dimensions chart.
WARNING:
 When drilling into concrete, eye protection is recommended
at all times.
2. Pre-drill holes for expansion bolts.
3. Make sure mounting holes are clear of debris.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled holes.
6. Remove the nuts from expansion bolts, and place outdoor unit on bolts.
7. Put washer on each expansion bolt, then replace the nuts.
8. Using a wrench, tighten each nut until snug.
WARNING:
 When drilling into concrete, eye protection is recommended
at all times.
If you will install the unit on a wall-mounted bracket , do the following:
CAUTION:
 Before installing a wall-mounted unit, make sure that the
wall is made of solid brick, concrete, or of similarly strong
material. The wall must be able to support at least four times
the weight of the unit.
1. Mark the position of bracket holes based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill the holes in the wall for the expansion bolts.
3. Clean dust and debris away from holes.
4. Place a washer and nut on the end of each expansion bolt.
5. Thread expansion bolts through holes in mounting brackets, put mounting
brackets in position, and hammer expansion bolts into the wall.
6. Check that the mounting brackets are level.
7. Carefully lift unit and place its mounting feet on brackets.
8. Bolt the unit fi rmly to the brackets.
Reduce vibrations of wall mounted unit
 If allowed, you can install the wall-mounted unit with rubber
gaskets to reduce vibrations and noise.