Use and Care Guide

8
|
Bosch Climate 5000 Series Wall Mounted Ductless Single Split Air Conditioner / Heat Pump User Manual
03.2019 | Bosch Thermotechnology Corp.
Data subject to change
2.4 Setting Angle of Air Flow
Setting vertical angle of air fl ow
While the unit is on, use the SWING /DIRECT button to set the direction (vertical
angle) of airfl ow.
1. Press the SWING /DIRECT button once to activate the louver. Each time you
press the button, it will adjust the louver. Press the button until the direction
you prefer is reached.
2. To make the louver swing up and down continuously, press and hold the
SWING/ DIRECT button for 3 seconds. Press it again to stop the automatic
function.
Figure 3
Range
NOTICE:
 Do not keep louver at too vertical an angle for long periods
of time. This can cause water condensation to drip from the
unit
Setting horizontal angle of air fl ow
CAUTION: PERSONAL INJURY
 Do not put your fingers in or near the blower and suction
side of the unit. The high-speed fan inside the unit may
cause injury.
The horizontal angle of the airfl ow must be set manually. Grip the defl ector rod (See
Fig.3) and manually adjust it to your preferred direction.
Figure 4
Deflector
rod
Louver angles
When using COOL or DRY mode, do not set louver at too vertical an angle for long
periods of time. This can cause water to condense on the louver blade, which will
drip from the unit.
When using COOL or HEAT mode, setting the louver at too vertical an angle can
reduce the performance of the unit due to restricted air fl ow.
Do not move louver by hand. This will cause the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a few seconds, then restart the unit. This
will reset the louver.