Operating instructions

4
NOTE:
The Outdoor Pack is not load bearing; it only provides
weather proofing for the boiler inside.
SERIAL NUMBER:
In any contact with Worcester Heat Systems quote your
boiler serial number, model and that it is fitted within the Outdoor
Pack. This will help identify spare parts and also avoid confusion
and delays during any service call-out.
You will find the boiler serial number on the front of the control
facia as shown in fig.1. Access can be gained by removing the
Outdoor Pack front cover and white front panel of the boiler
casing. (See section ‘Accessing your boiler controls.’)
TECHNICAL INFORMATION:
The Worcester Danesmoor Utility oil-fired pressure-jet
boiler when fitted inside the Outdoor Pack provides both domestic
hot water and full central heating, with outputs ranging from
12kW to 32kW (41,000 to 109,000 Btu/h).
The Worcester Bosch oil-fired pressure-jet boiler when fitted
inside Outdoor Pack provides both domestic hot water and full
central heating, with outputs ranging from 51,000 to 109,000 Btu/h.
Domestic hot water must be supplied via a conventional
indirect hot-water system, utilising an indirect double-feed
cylinder.
WARNING NOTE: Completely isolate the appliance
from inside the property before accessing your boiler controls.
The temperature control knob, overheat reset button and
lockout reset button are all located behind the white front panel of
the boiler casing within the Outdoor Pack.
To remove the Outdoor Pack front cover, remove the padlock,
if fitted, unscrew the two fixings pulling out and upward to release
the front cover. Then remove the white front panel of the boiler
casing by pulling forwards at the bottom end to release the lower
ball studs and repeat the procedure at the top end to release the
upper ones. Take care not to pull the bottom end too far forwards
as this may damage the spring clips
ACCESSING YOUR BOILER
CONTROLS