Wireless Remote Control

ManualsBrandsBosch ManualsPlumbingTherm 18" Natural Gas Tankless Water Heater With 199,000 BTU Max Input, Energy Star Rated, Electronic Ignition, 150 PSI Max Water Pressure, Non-Condensing, In Grey

12

Remote control installation

6 720 606 990

B On heater control panel, press and

hold Program key while

pressing the ON/OFF button to ON.

Release program key when LCD

displays “188”.

LCD shows “P2”. If not, repeat

previous step.

1.

Press the button on the

heater to select "P3".

B Press and hold Program key

again for 1 sec.

LCD shows one number and one

rotating digit. If not, repeat previous

step.

The number represents the remote

control which is to be registered, the

first remote control will be registered

with number “0”, the second with

number “1” and so on.

The rotating digit shows that the

electronics is expecting a registration.

If the LCD fails to show a number and

rotating digit after repeated attempts,

double check the wire connections

made in section 5.1.

B Hold remote control in front of the

control panel on the heater and

simultaneously press remote control

buttons and until the

temperature indication is shown on

the remote control LCD.

B Press ON / OFF button on the

appliance to OFF position and then

back ON.

B Press buttons or to reach

desired temperature.

New remote control is programmed.

6720606990-1005_(Remote control).fm Page 12 Thursday, July 1, 2010 11:46 AM