Installation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety Instructions
- Important Information
- Introduction
- Installing
- Operating
- Technical Data
- Appendices
- Index
- Back Page
Notice!
All connectors are pluggable screw clamp terminals.
Figure 3.5: Jumpers at the bottom side
7
Jumper for setting either voltage free relay output (“dry”
mode) or looped-in voltage from the AMC2 internal
power supply (“wet” mode).
8 DIL switch for setting the board address.
9 Jumper: Equalization of potential between different
systems and earth ground (shield) for the extension
interface.
Performance Characteristics
– Controlled by an AMC2 via RS-485
– 16 relay outputs
– voltage free, power is supplied externally (dry mode)
– powered by internal power supply (wet mode)
– 16 analog inputs with internal power supply
– Transfer rate to the extension interface: 9,6 kBit/s
3.3
AMC2 Extensions Introduction | en 15
Bosch Sicherheitssysteme GmbH 2013-08 | AMC2-16IOE |