Installation Manual
Table Of Contents
- Title Page
- Table of Contents
- Safety Instructions
- Important Information
- Introduction
- Installing
- Operating
- Technical Data
- Appendices
- Index
- Back Page
Connecting Power Supply
Direct Power Supply
Connect the power supply to the POWER 7-pin pluggable screw
connector. Refer to Connecting Diagrams, page 46 for a
complete diagram.
Figure 4.6: Location of the power supply connector
Connect an external power supply (10 - 30 Vdc) for AMC2-16IOE
at pin 1 (positive) and pin 3 (0 V) of the pluggable screw
connector.
If an uninterruptible power supply (UPS) is used, the relay
output for power good signals from the UPS is connected to the
following pins:
– pin 4 and 7 for power good AC
– pin 5 and 7 for power good Battery
– pin 6 and 7 for power good DC
Otherwise these pins must be short-circuited.
4.7
4.7.1
AMC2 Extensions Installing | en 27
Bosch Sicherheitssysteme GmbH 2013-08 | AMC2-16IOE |