Installation Manual

Operating
Status Display of the AMC2
Because the AMC2-16IOE has no display of its own, the AMC2
controller displays status information about the input and
output settings of the AMC2 extension boards.
The selected display mode remains set until the next time the
button is pressed. The order of the display pages is shown in
the following table. Display pages 3a to 3c include the
information about the I/O-Boards’ signals. For each I/O-Board
connected there is a separate display page.
Push
Display (Example) Description
0 V01.00 02.03.07 Software versions and date of
the firmware.
1a S/N1: 0910019212 BOSCH serial number
1b S/N2: 00000001
2 02.06 15:35:15 (S) Current date and time
(S) = Summer; (W) = Winter
3 Dig. IO: :::::::::::::::: Display of the digital contacts:
the input signals set will be
shown with an extension above
- output signals with an
extension below.
3a Dig. I1: :::::::::::::::: If there are I/O-Boards
connected the signals will be
shown on separate pages.
3b Dig. I2: ::::::::::::::::
3c Dig. I3: ::::::::::::::::
4 MAC 0010174C8A0C Network device address (MAC)
5
5.1
42 en | Operating AMC2 Extensions
2013-08 | AMC2-16IOE | Bosch Sicherheitssysteme GmbH