PSU-60 - AMC Power Supply Unit APS-PSU-60 en Installation Manual
PSU-60 - AMC Power Supply Unit Table of contents | en 3 Table of contents 1 Safety Instructions 4 1.1 Important Safety Notes 4 1.2 Safety Precautions 5 1.3 Unpacking 6 2 Important Information 7 2.1 Explanation of symbols in this document 7 2.2 Internet 7 3 System Overview 8 3.1 Features 8 3.2 Functions 8 3.3 Certifications and approvals 9 4 Installation 10 4.1 Parts Included 12 5 Technical data 13 Bosch Sicherheitssysteme GmbH Installation Manual 2016.03 | V1.
en | Safety Instructions PSU-60 - AMC Power Supply Unit 1 Safety Instructions 1.1 Important Safety Notes 1. Read, follow, and retain instructions - All safety and operating instructions must be read and followed properly before putting the unit into operation. Retain instructions for future reference. 2. Do not ignore warnings - Adhere to all warnings on the unit and in the operating instructions. 3.
PSU-60 - AMC Power Supply Unit 1.2 Safety Instructions | en 5 Safety Precautions Read instructions! Before working with the device, read these instructions carefully. Make sure you have understood all information described in this document. Warning! Risk of electric shock ! External power supplies must be installed and put into service by qualified personnel. Ensure compliance with the relevant regulations. Ground the controller.
en | Safety Instructions 1.3 PSU-60 - AMC Power Supply Unit Unpacking Check the packaging for visible damage. If anything has been damaged during transport, please inform the transport agency. Unpack the unit carefully. This is an electronic device that must be handled with care to avoid damage. Do not attempt to put the unit into operation if components are damaged. If any parts are missing, inform your customer service representative or a Bosch Security Systems salesperson.
PSU-60 - AMC Power Supply Unit 2 Important Information | en 7 Important Information Remarks This hardware is part of a security system. Access should be limited to authorized persons only. Some states do not allow the exclusion or limitation of implied warranties, or limitation of liability for incidental or consequential damages, hence the above limitation or exclusion might not apply to you. Bosch Security Systems retains all rights not expressly granted.
en | System Overview 3 PSU-60 - AMC Power Supply Unit System Overview The PSU-60 is a power supply unit with an integrated battery charging device. Includes preconfigured cable connectors for AMC controllers, I/O boards and batteries. 3.1 3.2 Features – Supports 12 V/7 Ah, 12 V/14 Ah and 24 V/7 Ah batteries – Selectable 12 VDC or 24 VDC voltage output – Selectable 5 A @ 12 VDC or 2.
PSU-60 - AMC Power Supply Unit System Overview | en 24V 12V 12V-mode 24V 12V 24V-mode 9 Notice! The power supply must only be installed by qualified personnel. 3.3 Certifications and approvals The product is classified in accordance with the following standards: – EN 55022 Class B – EN 55024 – IEC / UL / EN 60950 & CSA (product safety) – CE – RCM (Australia) – RoHS 2.0 Please refer to http://www.boschsecurity.com for further information.
en | Installation 4 PSU-60 - AMC Power Supply Unit Installation The PSU-60 can be mounted on rails and installed in the AMC housing. The PSU-60 dimensions are shown in the diagrams below: 2016.03 | V1.0.0 | DOC 1 140 mm (5.51 in.) 2 105 mm (4.13 in.) 3 Installation Manual 60 mm (2.36 in.
PSU-60 - AMC Power Supply Unit Installation | en 11 Alternatively, it can be screw-mounted directly to the wall. There are pre-drilled holes for this purpose on the base of the housing. These holes have the following dimensions: Ø1 8.6 mm (0.34 in.) C 99.5 mm (3.92 in.) Ø2 4.5 mm (0.18 in.) D 8.1 mm (0.32 in.) A 5.5 mm (0.22 in.) E 134.5 mm (5.30 in.) B 24 mm (0.94 in.) * Include tolerances (in mm) 0 – 5 mm = ±0.10 30 – 100 mm = ±0.30 5 – 30 mm = ±0.20 100 – 500 mm = ±0.
en | Installation PSU-60 - AMC Power Supply Unit The following diagram shows the connections to the AMC. 1 AC power 3 Temperature sensor 2 Battery connection 4 Power supply to AMC wiring connection * * For cables exceeding 3m, it is recommended to use a cylindrical Ferrite Core: – impedance @ 100 MHz = 90 or 140 Ω – min. inner diameter = 7.0 ± 0.8 mm – 100 MHz > Freq > 25 MHz 4.1 Parts Included The components supplied are as follows: – Power supply – Plug – 2016.03 | V1.0.
PSU-60 - AMC Power Supply Unit 5 Technical data | en 13 Technical data Output values Output voltage: Output current: 12V mode 10-15V 24V mode 20-30V 12V mode max. 5A 24V mode max. 2.5A Output power: Over voltage protection at: 60 W (constant) 12V mode 16.5V 24V mode 33V Input values Input voltage: AC 100-240V~, 50-60Hz Input current (AC): Max. 2A, to the specified max. load at 85 VAC Input protection in case of a failure, the primary voltage is cut off from the power supply by a fuse.
Bosch Sicherheitssysteme GmbH Robert-Bosch-Ring 5 85630 Grasbrunn Germany www.boschsecurity.
