Installation Manual
Table Of Contents
- Table of Contents
- 1 Safety precautions
- 2 Basics of fingerprint recognition
- 3 How to place a finger
- 4 Product Contents
- 5 Description
- 6 Product Dimension
- 7 Cables and Connectors
- 8 Installation of Wall-mount Bracket
- 9 Connections
- 10 Network Default Setting
- 11 Installation References
- 12 Electrical Specification
- 13 Troubleshooting
- 14 Device Cleaning
- 15 FCC Rules
- 16 Specifications
BioEntry Plus Connections | en 21
Bosch Access Systems GmbH Installation manual | V 1.1 | 2010.10
RS485 Connection for Secure I/O
NOTICE!
– Adjust the communication speed as needed. The signal
quality vary depending on wiring conditions, and it may be
necessary to lower the baudrates.
– The GND signal may be omitted if and only if the GND
potential difference is less than ± 5V.
1 = Only the devices at the both ends of the bus should be
terminated. To enable termination on the RS232-485
converter, refer to the converter’s manual.
2 = The stubs should be as short as practical.
NOTICE!
Maximum number of devices in an RS485 loop is eight (8)
including Host PC or Host device. Each device can connect
Secure I/Os up to four (4)