Quick Start Guide

8001193696
(0004)
en-us, fr-ca
1. Remove information material,
adhesive tape and protective foil.
2. Remove the power cord and
the equipment package from the
appliance.
3. Clean the appliance.
4. Roll appliance to its final location.
1. Press any button on the cool-fresh compartment controls.
2. Press and hold the unlock button of the cool-fresh compartment
controls, until the light bar lights up completely.
3. Press your desired storage setting button.
 Bottle shelf (bottom): up to 7 bottles
 Bottle shelf (top): up to 8 bottles
 Bottle shelf (front): up to 2 bottles
1. Press menu button.
2. Press light settings button.
3. Press Y/X Settings button
repeatedly until the settings
display shows the desired
brightness level.
 Leave a clearance of 1/2 ˝
(12.7 mm) above the appliance.
Observe minimum clearances as
follows:
 If you install the appliance in
a niche, adhere to the following
dimensions:
First steps
Quickstart Helpful Hints
Setting bottle storage compartment
Equipment Bar
Cleaning your appliance
Loading bottles
Lighting customization
Minimum clearances
Niche dimensions
Align the vertical gap
between the doors
Align the horizontal gap
between the doors
Installing the equipment
Water and electrical
connection
Purge the water system
Aligning the appliance
Note:
Note:
Note:
Note:
Never use stainless steel
cleaners on the exterior of
the appliance.
Not all bottle sizes can be stored.
To create storage space for larger
bottles, take out the bottle shelf (top).
0 = lighting o
1 = minimum brightness
5 = maximum brightness
For important safety instructions, information on installation, use and
maintenance of the appliance, please refer to the entire user manual.
1. Using a wrench, screw down both
height adjustable feet, so that
they firmly touch the floor.
2. Adjust each separately, so that
the appliance is also aligned and
straight.
3. Use a level to confirm.
 Install the loose equipment parts
as shown in the appliance
overview picture.
 You can adjust the equipment bar vertically and move the
bin (hanging), shelf (hanging) and bottle shelf (hanging) sideways.
 Clean the appliance with a
soft cloth, lukewarm water
and a little pH-neutral
cleaning liquid.
 Connect water supply on the rear
of the appliance.
 Insert the power cord plug on the
rear of the appliance and into an
outlet.
1. Hold the glass under the
water dispenser.
2. Push the glass upwards against
the dispenser lever or press
è button and dispense water
for 5 minutes, approximately
3 gallons.
3. Discard the ice produced within
the first 24 hours. If ice cube
production is switched on, the ice
maker " button lights up.
→ refer to "Getting to know your
appliance" in the user manual, page 14
→ refer to "Installing the appliance"
in the user manual, page 8
→ refer to "Bottle storage compartment controls" in the user manual,
page 16
→ refer to "Installing the appliance"
in the user manual, page 9
13
1
2
3
4
5
6
7
8
9
A
B
E
C
D
⅛ ″ (3,2 mm)
⅛
″ (3,2 mm)
1 ″ (25 mm)
36 ″
(914 mm)
72 ″
(1830 mm)
25 ″
(635 mm)
1. Download the
Home Connect (America) app.
2. Scan the QR code and follow
the instructions in the app.
Connect your appliance
F