Interactive User Manual

en-us Water system
20
14.2 Water dispenser
Dispense cold water via the water dispenser.
Putting the water dispenser into operation
Note:Once the appliance has been connected or a new
water filter has been installed, there will be air in the water
system.
1. Keep dispensing water until it contains no more air bub-
bles.
Remove any splashes of water with a dry cloth.
2. For hygiene reasons, dispense water for 5minutes and
discard.
Dispensing water
▶
Press and hold the glass against the dispensing button
or hold the glass under the water dispenser and
press ⁠.
Notes
¡ After a while of continuous dispensing, the water
stops being dispensed. Wait a few seconds before
dispensing water again.
¡ After water has been dispensed several times con-
secutively, water stops being dispensed. Wait a few
minutes before dispensing water again.
14.3 Ice maker
Use the ice maker to produce ice cubes.
WARNING
Rotating parts may cause injury.
▶
Never reach into or underneath the ice maker.
Note:The ice maker automatically detects that the ice
storage container is full.
It could take up to 48hours until the ice storage container
is full.
Tips
¡ You can accelerate ice cube production by setting a
colder freezer compartment temperature or by switching
on Super freezing. This will slightly increase energy
consumption.
¡ If the ice cubes taste stale, discard them and the cubes
produced over the next 24 hours. If the ice cubes still
taste stale, change the water filter.
Putting the ice maker into operation
Notes
¡ Ice cube production starts as soon as the appliance is
switched on and the freezer compartment has reached
the set temperature.
¡ As soon as the freezer compartment reaches the set
temperature, the first batch of ice cubes will be ready in
approximately 4hours.
▶
For hygiene reasons, discard the ice cubes produced
within the first 24hours.
Switching on ice cube production
▶
Lift the ice maker cover upwards and press the ice
maker button ⁠.
a The ice maker button lights up.
Note:If you press and hold the ice maker button for 3 sec-
onds, the filter change status is reset.
Switching off ice cube production
▶
Lift the ice maker cover upwards and press the ice
maker button ⁠.
a The ice maker button goes out.
Note:If you press and hold the ice maker button for 3 sec-
onds, the filter change status is reset.