Installation Instructions

R/PWR terminal and power output of the interconnect
connector (SDI2 power)
R
PWR
Power SDI2 devices such as a B208 Octo-input Module, a B308
Octo-output Module, or keypads.
Plug-in module connector
Connect plug-in modules such as the B440 Conettix Plug-in
Cellular Communicator.
OUTPUT A
NO C NC
OUTPUT A
Configure Output A as a dry contact (contact rating is 3 Amps),
switched common (sink current), or a powered output. As a
powered output, it can provide alarm power or switched
auxiliary power. The default configuration for Output A makes it
a powered output providing alarm power. Use OUTPUT
PARAMETERS in RPS to configure programmable outputs.
Open collector outputs
OUTPUT B and C
B C
OUTPUT
Outputs B and C are open collector outputs that can sink up to
50 mA of power (+12 VDC), when activated.
As an example, the figure below shows using Outputs B and C to
trigger the relays of a D134 Dual Relay Module.
5.3
Control Panels On-board outputs | en 29
Bosch Security Systems, Inc. 2015.09 | 08 | F.01U.287.185