Installation Manual
Table Of Contents
- Title Page
- Table of Contents
- Certifications, approvals, listings, and safety
- Introduction
- System overview
- Installation checklist
- Control panel installation
- Power supply
- Telephone communications
- IP communications
- Keypads, keyswitches, keyfobs and transmitters
- Keypads
- B915 Basic Keypad
- B920 Two-line Alphanumeric Keypad
- B921C Two-line Capacitive Keypad with Inputs
- B930 ATM Style Alphanumeric Keypad
- B942 Touch Screen Keypad
- Shortcuts and custom functions
- Address settings
- Supervision
- Installation and control panel wiring (keypads)
- Sensor loops overview and wiring (B921C/B942/B942W only)
- Output wiring (B942/B942W only)
- Troubleshooting
- Keyswitches
- RADION keyfobs and Inovonics pendant transmitters
- Keypads
- On-board outputs
- Off-board outputs
- On-board points
- Off-board points
- Wireless modules
- Access control
- Program and test the control panel
- Control panel board overview
- System wiring diagrams
- Approved applications
- Keypad Installer menu
- [1] Program menu
- [1] Reporting > [1] Phone menu parameters
- [1] Reporting > [2] Network menu parameters
- [1] Reporting > [3] Routing menu parameters
- [1] Reporting > [4] Personal Note menu parameters
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [1] Module Parameters menu
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [2] Address Parameters menu
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3] DNS Parameters menu
- [2] Network > [2] Cellular > (choose the SDI2 cellular module or plug-in module)
- [3] RPS > [1] RPS Passcode menu parameters
- [3] RPS > [2] RPS Phone Number menu parameters
- [3] RPS > [3] RPS IP Address menu parameters
- [3] RPS > [4] RPS Port Number menu parameters
- [4] Area Options menu parameters
- [5] Keypad menu parameters
- [6] Users menu parameters
- [7] Points menu parameters
- [8] Disable Programming menu
- [2] Wireless menu
- [1] RF Point Menu> [1] Enroll Point RFID
- [1] RF Point Menu> [2] Replace Point RFID
- [1] RF Point Menu> [3] Remove Point RFID
- [2] RF Repeater Menu > [1] Add Repeater
- [2] RF Repeater Menu > [2] Replace Repeater
- [2] RF Repeater Menu > [3] Remove Repeater
- [3] RF Diagnostic Menu > [1] RF Points
- [3] RF Diagnostic Menu > [2] RF Repeater Menu
- [3] Diags menu
- [4] Serv Byp (Service Bypass) menu
- [5] Versions menu
- [6] Cloud menu
- [1] Program menu
- Specifications
- Appendix
- Back Page
Point Indexes (point profiles) 17 through 20
Point Index Text defaults (the second language text defaults are blank):
Point Index Number Default text (first language)
Point Index 17 Gas
Point Index 18 Gas: Supervisory
Point Index 19 Aux AC Supervision
Point Index 20 Part On: Watch Off
Point Index # 17 18 19 20
Point Index Text
(1st language)
Gas Gas
Supervisi
Aux AC
Supervisi
Part On
Watch Off
Point Index Text
(2nd language)
(blank) (blank) (blank) (blank)
Point Type / Response /
Circuit Style
Gas Point Gas Point Aux AC
Supervisi
Part On
Entry Delay _(30)_ _(30)__ _(30)_ _(30)_
Entry Tone Off Y/N Y/N Y/N Y/N
Silent Bell Y/N Y/N Y/N Y/N
Ring Until Restored Y/N Y/N Y/N Y/N
Audible After Two Fails Y/N Y/N Y/N Y/N
Invisible Point Y/N Y/N Y/N Y/N
Buzz on Fault __(0)__ __(0)__ __(0)__ __(0)__
Watch Point Y/N Y/N Y/N Y/N
Output Response Type __(0)__ __(0)__ __(0)__ __(0)__
Display as Device Y/N Y/N Y/N Y/N
Local While Disarmed Y/N Y/N Y/N Y/N
Local While Armed Y/N Y/N Y/N Y/N
Disable Restorals Y/N Y/N Y/N Y/N
FA Returnable Y/N Y/N Y/N Y/N
Bypass Returnable Y/N Y/N Y/N Y/N
Bypassable Y/N Y/N Y/N Y/N
Swinger Bypass Y/N Y/N Y/N Y/N
Report Bypass at Occurrence Y/N Y/N Y/N Y/N
Defer Bypass Report Y/N Y/N Y/N Y/N
Cross Point Y/N Y/N Y/N Y/N
Alarm Verify Y/N Y/N Y/N Y/N
Resettable Y/N Y/N Y/N Y/N
Control Panel Keypad Installer menu | en 131
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.05 | 14 | F.01U.287.180