Installation Manual

B93x/B94x keypads configuration of Keypad Programming
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [8] Disable Programming. The keypad display shows that
programming is enabled.
3. Press [Edit] to disable keypad programming.
4. Press [No].
5. Press [Save] to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
[2] Wireless menu
Use the Wireless menu to add, replace, remove, and diagnose points and repeaters.
[1] RF Point Menu> [1] Enroll Point RFID
Once the control panel has points programmed as Wireless (refer to B91x/B92x keypads
configuration of Point Source, page 134), you can enroll RF devices into the system as a
specified wireless points. In this menu, you can enroll RFID points.
Enroll Point RFID
B91x/B92x keypads use of Enroll Point RFID
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [1] RF Point Menu> [1] Enroll Point RFID. The keypad lists any
enrolled points.
3. Use [PREV] or [NEXT] to scroll though the list of wireless points, and go to the point for
which you want to enroll a device, or simply enter the point number.
4. Press [ENTER] to add the device. The keypad instructs you to reset the device.
5. Initiate activity for the desired RADION device (walk through the coverage pattern if
enrolling a motion detector, or press the button on the keyfob if enrolling a keyfob, or
open the door or window if enrolling a door/window contact), or press the RESET button
on an Inovonics device.
6. When the keypad shows Point Enrolled, escape from the menu.
7. Verify the RFID shown on the keypad matches the RFID label on the activated device.
B93x/B94x keypads use of Enroll Point RFID
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Program > [1] RF Point Menu> [1] Enroll Point RFID.
3. Use
/[PREV] or /[NEXT] to scroll though the list of wireless points, and go to the
point for which you want to enroll a device, or simply enter the point number.
4. Press [Yes] to add the device. The keypad instructs you to reset the device.
5. Initiate activity for the desired device (walk through the coverage pattern if enrolling a
motion detector, or press the button on the keyfob if enrolling a keyfob, or open the door
or window if enrolling a door/window contact), or press the RESET button on an
Inovonics device.
6. When the keypad shows Point Enrolled, escape from the menu.
7. Verify the RFID shown on the keypad matches the RFID label on the activated device.
[1] RF Point Menu> [2] Replace Point RFID
In this menu, you can replace RFID points.
Replace Point RFID
20.2
20.2.1
20.2.2
136 en | Keypad Installer menu Control Panel
2016.05 | 14 | F.01U.287.180 Installation and System Reference Guide Bosch Security Systems, Inc.