Installation Manual

[2] RF Repeater Menu > [3] Remove Repeater
In this menu, you can replace Repeater points.
Remove Repeater
B91x/B92x keypads use of Remove Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [2] RF Repeater Menu > [3] Remove Repeater. The keypad lists any
existing repeaters.
3. Use [PREV] or [NEXT] to scroll though the list of repeaters, and go to the repeater you
want to remove, or simply enter the repeater number.
4. Press [ENTER] to remove the device. The keypad removes the device and shows Repeater
Removed.
5. Escape from the menu.
B93x/B94x keypads use of Remove Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Program > [1] RF Point Menu> [3] Remove Point RFID. The keypad lists any
existing repeaters.
3. Use
/[PREV] or /[NEXT] to scroll though the list of repeaters, and go to the repeater
you want to remove, or simply enter the repeater number.
4. Press [Remove] to remove the repeater. The keypad removes the device and shows
Repeater Removed.
5. Escape from the menu.
[3] RF Diagnostic Menu > [1] RF Points
You can obtain certain wireless point diagnostic information using a keypad and this menu.
States (for RF points)
B91x/B92x keypads use of States (for RF points)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Menu> [1] State.
3. Use [PREV] or [NEXT] to scroll though the list, and go to the point for which you want to
view diagnostic information, or enter the point number.
4. Press [ENTER] to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
5. When finished viewing the information, escape from the menu.
B93x/B94x keypads use of States (for RF points)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Menu> [1] State menu.
3. Use /[PREV] or /[NEXT] to scroll though the list, and go to the point for which you
want to view diagnostic information, or enter the point number and press [ENTER].
4. Press [State] to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
5. When finished viewing the information, escape from the menu.
Signal Strength (for RF points)
20.2.6
20.2.7
Control Panel Keypad Installer menu | en 139
Bosch Security Systems, Inc. Installation and System Reference Guide 2016.05 | 14 | F.01U.287.180