Installation Manual
Table Of Contents
- Title Page
- Table of Contents
- Certifications, approvals, listings, and safety
- Introduction
- System overview
- Installation checklist
- Control panel installation
- Power supply
- Telephone communications
- IP communications
- Keypads, keyswitches, keyfobs and transmitters
- Keypads
- B915 Basic Keypad
- B920 Two-line Alphanumeric Keypad
- B921C Two-line Capacitive Keypad with Inputs
- B930 ATM Style Alphanumeric Keypad
- B942 Touch Screen Keypad
- Shortcuts and custom functions
- Address settings
- Supervision
- Installation and control panel wiring (keypads)
- Sensor loops overview and wiring (B921C/B942/B942W only)
- Output wiring (B942/B942W only)
- Troubleshooting
- Keyswitches
- RADION keyfobs and Inovonics pendant transmitters
- Keypads
- On-board outputs
- Off-board outputs
- On-board points
- Off-board points
- Wireless modules
- Access control
- Program and test the control panel
- Control panel board overview
- System wiring diagrams
- Approved applications
- Keypad Installer menu
- [1] Program menu
- [1] Reporting > [1] Phone menu parameters
- [1] Reporting > [2] Network menu parameters
- [1] Reporting > [3] Routing menu parameters
- [1] Reporting > [4] Personal Note menu parameters
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [1] Module Parameters menu
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [2] Address Parameters menu
- [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3] DNS Parameters menu
- [2] Network > [2] Cellular > (choose the SDI2 cellular module or plug-in module)
- [3] RPS > [1] RPS Passcode menu parameters
- [3] RPS > [2] RPS Phone Number menu parameters
- [3] RPS > [3] RPS IP Address menu parameters
- [3] RPS > [4] RPS Port Number menu parameters
- [4] Area Options menu parameters
- [5] Keypad menu parameters
- [6] Users menu parameters
- [7] Points menu parameters
- [8] Disable Programming menu
- [2] Wireless menu
- [1] RF Point Menu> [1] Enroll Point RFID
- [1] RF Point Menu> [2] Replace Point RFID
- [1] RF Point Menu> [3] Remove Point RFID
- [2] RF Repeater Menu > [1] Add Repeater
- [2] RF Repeater Menu > [2] Replace Repeater
- [2] RF Repeater Menu > [3] Remove Repeater
- [3] RF Diagnostic Menu > [1] RF Points
- [3] RF Diagnostic Menu > [2] RF Repeater Menu
- [3] Diags menu
- [4] Serv Byp (Service Bypass) menu
- [5] Versions menu
- [6] Cloud menu
- [1] Program menu
- Specifications
- Appendix
- Back Page
Panel event Modem4 code
D6500 mode
Modem4 code
Bosch SIA mode
Contact ID event Contact ID code
Relay Set by User NsD28 NidiiiiRCrrrr Sounder/Relay Set 1 320 00 000
Remote Reset – System was
reset by RPS
NsD11 NRN System Reset 1 305 00 000
Remove User’s Key Fob
(Assign Card Event)
NsD30 NidiiiiDAuuuu Local Only Local Only
Replace Sensor Tpppp NriaaBTpppp Maintenance Alert 1 393 aa ppp
Replace Sensor Restore Rpppp NriaaBRpppp Maintenance Alert Restore 3 393 aa ppp
Replace User’s Key Fob
(Assign Card Event)
NsD30 NidiiiiDAuuuu Local Only Local Only
Restoral Rpppp NriaaBRpppp Sensor Trouble Restore 3 380 aa ppp
Restoral from Alarm Rpppp NriaaBHpppp Burglary Restore 3 130 aa ppp
RF Interference TsD08 NpiddddXQ RF RCVR Jam 1 344 00
1
zzz
RF Interference Restore RsD08 NpiddddXH RF RCVR Jam Restore 3 344 00
1
zzz
RF Transmitter Hss001 NriaaFRpppp Maintenance Alert Restore 3 393 aa ppp
RF Transmitter Low Battery Tspppp NriaaXTpppp RF Low Battery 1 384 aa ppp
RF Transmitter Low Battery
(Key Fob)
TsD10 NidiiiiXT Battery Test Failure 1 309 00 uuu
RF Transmitter Low Battery
(Key Fob) Restore
RsD10 NidiiiiXR Battery Test Restore 3 309 00 uuu
RF Transmitter Low Battery
Restore
Rspppp NriaaXRpppp RF Low Battery 3 384 aa ppp
RF Transmitter Maintenance Gss001 NriaaFTpppp Maintenance Alert 1 393 aa ppp
ROM Checksum Fail AsD12 NYX ROM Checksum bad 1 304 00 000
SDI Device AC Fail TsssD NEP Exp. Module AC Loss 1 342 00
1
zzz
SDI Device AC Fail Restore RsssD NEQ Exp. Module AC Restore 3 342 00
1
zzz
SDI device is missing TssssD NpiddddET Expansion Module Failure 1 333 00 000
SDI device is restored RssssD NpiddddER Expansion Module Failure
Restore
3 333 00 000
SDI Device Low Battery TsssDt NpiddddEBbb Exp. Module Low Batt. 1 338 00
1
zzz
SDI Device Low Battery
Restore
RsssDt NpiddddEVbb Exp. Module Batt. Restore 3 338 00
1
zzz
SDI Device Missing TsssDt NpiddddEM Exp. Module Failure 1 333 00
1
zzz
SDI Device Missing Battery TsssDt NpiddddEBbb Exp. Module Low Batt.
Restore
3 338 00
1
zzz
158 en | Appendix Control Panel
2016.05 | 14 | F.01U.287.180 Installation and System Reference Guide Bosch Security Systems, Inc.