Manual - BCM8450UC

9
en
Initial use
Setting up the appliance
■ Remove any protective plastic lm.
NOTICE:
Only use the appliance in a frost-free room.
If it has been transported or stored at tem-
peratures below 32°F, wait at least 3 hours
before initial use.
■ Take hold of the appliance door by the
recessed grip and open.
■ Remove the water tank, rinse it and ll it
with fresh water up to the “max” mark.
■ Replace the water tank and click into
place.
■ Remove the bean container, ll with
coffee beans and replace.
■ Set the power switch to I and close
the appliance door.
The appliance heats up and is rinsed.
The control panel is activated.
“Language” appears.
■ Turn the control ring with your nger to
select the desired language and press the
[ Water hardness ] eld.
Note:
It is important to set the water hardness
correctly to enable the appliance to accu-
rately indicate when the descaling program
should be run. The preset water hardness
is level 4. If a water softener is installed in
the house, please set the water hardness to
level 3. You can also check the water hard-
ness by asking your local water supplier.
■ Use the enclosed test strip to determine
the water hardness. Briey dip the test
strip in water and check the result after
one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
■ Turn the control ring with your nger to
set the water hardness determined.
■ Press [ Set-up complete ]. The settings are
saved.
The appliance is ready to use as soon
as the drink images are shown and the
m lights up.
The integrated fan switches on each time
a drink is dispensed and switches off again
after a few minutes.
Note:
When the appliance is used for the rst time
after running a service program, or if it has
not been operated for a long period, the rst
beverage will not have the full aroma.
When the fully automatic coffee machine
is rst used, a suitable thick and stable
“crema” is only achieved after the rst few
cups have been dispensed.
Switch off appliance
■ Press I.
The appliance rinses and switches to
energy saving mode.
Exception: If only hot water is dispensed,
the appliance switches off without rinsing.
■ To switch the appliance off completely,
open the appliance door and set the
power switch to h.
NOTICE:
Do not press the power switch while the
appliance is in use.
Note:
The factory settings of the fully automatic
coffee machine are programmed for optimal
performance. The appliance switches auto-
matically to the energy saving mode after
a specied time and rinses (duration can
be set, see “Switch off after” in the section
“Menu”).
Note:
The appliance is equipped with a sensor.
If there is a milk container, this will be
correspondingly shown on the display when
switching to the energy saving mode. If
there is milk in the container, please store in
the fridge.