Manual - BCM8450UC

27
en
Tips on energy saving
Note:
If there is not enough descaling solution in
the water tank, you will be asked to do the
following. Refill using uncarbonated water
and press C again.
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container.
■ Close the appliance door.
■ Place a container with a capacity of 17 oz
under the beverage outlet.
■ Press C.
The program will now run for about
19 minutes.
■ Remove the container and press C.
■ Rinse the water tank and (if removed)
replace the water lter.
■ Fill the tank with fresh water up to the
“max” indicator.
■ Replace the water tank and close the door.
■ Place the container underneath the
beverage outlet again.
■ Press C.
The program will now run for about
7 minutes and rinse the appliance.
■ Remove the container, empty the drip
trays, replace and close the appliance door.
■ Press C. The appliance is descaled,
cleaned and ready for use again.
■ Press E to exit the program.
Special rinsing
NOTICE:
If any of the service programs are ever
interrupted, for instance by a power failure,
please proceed according to the informa-
tion on the display:
■ Rinse the water tank and rell it with fresh
water up to the “max” mark.
■ Press C. The program will now run for
about 2 minutes and rinse the appliance.
■ Empty the drip trays, replace and close
the appliance door. The appliance is
ready for use again.
■ Press E to exit the program.
Tips on energy saving
■ Press I to switch the appliance to
“energy saving mode”. The appliance
uses very little power when in “energy
saving mode”, but monitors all safety-
relevant functions so as to avoid damage.
■ In the menu under “Switch off after”,
set the automatic switch off period to
15 minutes.
■ Reduce the brightness of the display
and the illumination in the menu to save
energy.
■ If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray lls up
more quickly.
■ Descale the appliance regularly to avoid a
build-up of limescale. Limescale residues
cause higher energy consumption.
Frost protection
To prevent frost damage during trans-
port and storage, completely empty the
appliance beforehand (see the section
“Menu – Frost protection”).
Storing accessories
The fully automatic coffee machine has a
special accessory drawer for storing the
Quick reference guide and the accessories
in the appliance.
■ Put the measuring spoon and the water
lter into the accessory drawer.
■ Put the Quick Reference Guide into the
special support at the front of the acces-
sory drawer.
■ The long suction pipe can be stored
in the holder on the inside of the door
(Figure D).
■ The connecting element can be xed to
the magnetic holder above the ground
coffee drawer.