%JTIXBTIFS FO 0QFSBUJOH JOTUSVDUJPOT
5HVHW VHF 6WDUW
en Table of contents Safety instructions . . . . . . . . . . . . . . . . . 4 Before you switch ON the appliance . . 4 Delivery . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . 4 In daily use . . . . . . . . . . . . . . . . . . . . . 4 Children in the household . . . . . . . . . . 4 Door lock . . . . . . . . . . . . . . . . . . . . . . 5 Damage . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . . . . . . . . . . . . . . . . .
en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. Retain all documents for subsequent use or for the next owner. Delivery – Check the packaging and dishwasher immediately for damage caused in transit. Do not switch on a damaged appliance, but contact your supplier. – Please dispose of the packaging material in an environmentally friendly manner.
en Childproof lock (door lock) * okclDr The description of the childproof lock is at the back in the envelope. * depending on model Damage – The appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap. Disposal – Make redundant appliances unusable to prevent subsequent accidents. – Dispose of the appliance in an environmentally friendly manner.
en Water softening system To ensure good washing results, the dishwasher requires soft water, i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container. Tap water above 9° Clarke must be softened. The water is softened with salt (regeneration salt) in the water softening system of the dishwasher. The setting and therefore the required amount of salt depends on the degree of hardness of your tap water (see table).
en Special salt $ Using special salt Always refill with special salt immediately before switching on the appliance. This ensures that overrun special salt solution is immediately washed out and does not corrode the rinsing tank. – Open the screw-type cap of the compartment 1J. – Fill the tank with water (only required when switching on the appliance for the first time). – Then add dishwasher salt (not table salt or tablets). The water is displaced and runs out.
en Setting amount of rinse aid Rinse aid % As soon as the rinse-aid refill indicator ` is lit on the fascia, there is still a rinse-aid reserve of 1 – 2 rinsing processes. Refill with rinse aid. The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid for domestic dishwashers. Combined detergents with rinse-aid component may be used up to a water hardness of 21° dH (37° fH, 26° Clarke, 3.7 mmol/l) only. If the water hardness is over 21° dH, rinse aid must be used.
en Utensils Not suitable – Cutlery and utensils made of wood. – Delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof. – Plastic parts not resistant to heat. – Copper and tin utensils. – Utensils which are soiled with ash, wax, lubricating grease or ink. Aluminium and silver parts have a tendency to discolour and fade during the wash cycle. Even some types of glass (e.g. crystal glass objects) may turn cloudy after many wash cycles.
en Pans Bottom basket 1b Etagere * reEtag The etagere and the space underneath can be used for small cups and glasses or for larger items of cutlery, such as wooden spoons or serving cutlery. The etagere can be folded up if not required. &/,&. Tip Heavily soiled utensils (pans) should be placed in the bottom basket. The more powerful spray jet provides a better dishwashing result. Tip Other examples, such as the best way of loading your dishwasher, can be found on our homepage as a free download.
en Small accessories holder * adelmroschiS * depending on model Light-weight plastic accessories, e.g. cups, lids, etc. can be held securely in the small accessories holder. Adjusting the height of the basket * tekshbagudhtofeisjAn * depending on model If required, the height of the upper utensils basket 1" can be adjusted to provide more space for tall utensils either in the upper or lower basket. Appliance height 81.5 cm Top basket Setting 1 max. ø Setting 2 max. ø Setting 3 max. ø 22 cm 24.
en Top basket with side levers – Pull out the top basket 1" out. – To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping. – To raise the basket, hold the basket on the sides of the upper edge and lift it up. – Before re-inserting the basket again, ensure that it is at the same height on both sides.
en Adding detergent – If the detergent dispenser 9" is still closed, press the lock 9* to open the detergent dispenser. Pour detergent into the dry detergent dispenser 9" only (insert tablet flat, not on its edge). Dosage: see manufacturer’s instructions on the packaging. The graduated detergent dispenser 9" helps you add the correct amount of powder or liquid detergent. Usually 20 ml–25 ml are adequate for normal soiling. If using tablets, one tablet is adequate.
en Notes – You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. – If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue. It is recommended to use washing powder for these programmes. – The Intensive programme (on some models) requires one tab only.
en Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia.
en Additional options * depending on model Additional options can be set with the buttons X. Ÿ Express Wash/ Speed Perfect/ ods)ehcSit(VPr/pWaExf (VarioSpeed) * This function can reduce the running time by approx. 20% to 50% depending on the selected rinse programme. The change in the running time is indicated on the digital display H. To obtain optimum cleaning results at a reduced running time, water and energy consumption are increased. § Half load * fodaHl If you have only a few items to wash (e.
en Timer programming * nmargoipeT * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Close the door. – Switch on ON/OFF switch (. – Press button P until the digital display H jumps to œ:‹‚. – Press button P until the displayed time corresponds with your requirements. – Press START button @, timer programming is activated. – To delete the preselected starting time, press the button P until œ is indicated on the digital display.
en Terminating the programme (Reset) nmamgtheproaiTgmre – Press START button @ for approx. 3 sec. The numerical display H indicates ‹:‹‚. – The programme sequence lasts approx. 1 min. On the digital display H is indicated ‹:‹‹. – Switch off ON/OFF switch (. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset).
en Filters Spray arms The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. – After each washing cycle check the filters for residue. – Unscrew filter cylinder as illustrated and take out filter system. Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 1: and 1B.
en Troubleshooting The majority of faults which could occur in daily operation can be rectified by the user. This ensures that the appliance is quickly available for use again. The following overview will help you locating the causes and gives helpful advise to eliminate them. Note If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset).
en ... when the appliance is switched on The appliance does not start. – The mains fuse has tripped. – The appliance plug has not been inserted. – The appliance door has not been shut properly. – Filter in the water supply blocked. – Switch off the appliance and pull out the mains plug. – Turn off the tap. – Clean filter in the supply hose. ... on the appliance Lower spray arm rotates sluggishly. – Spray arm blocked. The door is difficult to open. * – Child-proof lock is activated.
en ... during the wash cycle Unusual foam formation. – Handwash liquid in the rinse aid dispenser. Spilled rinse aid causes excessive frothing, therefore please remove with a cloth. Appliance stops during the wash cycle. – Power supply interrupted. – Water supply interrupted. Filling valves making striking noises – Caused by the installation of the water line and has no effect on the function of the machine. Remedial action is not possible.
en Customer service If the advice given does not resolve your problem, please contact your customer service. Contact details can be found on the back cover of this instruction manual or in the enclosed customer service list. When calling , please quote the appliance number (1) and the production date (FD = 2) which can be found on the rating plate 92 on the appliance door. )' Rely on the expertise of the manufacturer.
en – After installing the appliance, ensure that the plug is easily accessible. (see Electrical connection) – Some models: The plastic housing on the water connection contains an electric valve, the connecting cables are in the supply hose. Do not cut through this hose, do not immerse the plastic housing in water. ã=Warning If the appliance is not in a cavity and a side panel is accessible, the door hinge area must be covered at the side for reasons of safety (risk of injury).
en Warm water connection Electrical connection * depending on model The dishwasher can be connected to cold or hot water up to max. 60 °C. Connection to hot water is recommended if the hot water can be supplied by energetically favourable means and from a suitable installation, e. g. solar heating system with circulation line. This will save energy and time. The hot water setting ‘:‹‚ allows you to adjust your appliance optimally to operation with hot water.
en Transportation Empty the dishwasher and secure loose parts. Drain the appliance according to the following steps: – Turn on the tap. – Close the door. – Switch on ON/OFF switch (. – Select programme with the highest temperature. The expected programme duration is indicated on the numerical display H. – Press START button @. Programme sequence starts. – After approx. 4 minutes press the START button @ until ‹:‹‚ is indicated on the digital display. After approx.
&KLOGSURRI ORFN GRRU ORFN $FWLYDWH WKH FKLOGSURRI ORFN 2SHQ WKH GRRU ZLWK DFWLYDWHG FKLOGSURRI ORFN 'HDFWLYDWH FKLOGSURRI ORFN $OZD\V FORVH WKH DSSOLDQFH GRRU FRPSOHWHO\ ZKHQ \RX OHDYH WKH DSSOLDQFH 7KLV LV WKH RQO\ ZD\ \RX FDQ SURWHFW \RXU FKLOGUHQ IURP SRWHQWLDO GDQJHUV %DNLQJ VKHHW VSUD\ KHDG /DUJH VKHHWV RU JULOOHV DQG SODWHV ZKLFK KDYH D GLDPHWHU JUHDWHU WKDQ FP JRXUPHW SODWHV SDVWD SODWHV GLQQHU SODWHV FDQ EH FOHDQHG ZLWK WKH DLG RI WKH VSUD\ KHDG 7R GR WKLV UH
EPFT OPU BQQMZ UP BQQMJBODFT XJUIPVU "RVB4UPQ $TXD6WRS JXDUDQWHH *O BEEJUJPO UP XBSSBOUZ DMBJNT BHBJOTU UIF TFMMFS CBTFE PO UIF QVSDIBTF DPOUSBDU BOE JO BEEJUJPO UP PVS BQQMJBODF XBSSBOUZ XF XJMM QBZ EBNBHFT VOEFS UIF GPMMPXJOH DPOEJUJPOT *G PVS "RVB4UPQ TZTUFN JT EFGFDUJWF BOE DBVTFT XBUFS EBNBHF XF XJMM NBLF HPPE UIF EBNBHF GPS QSJWBUF VTFST 5P FOTVSF XBUFS EBNBHF QSPUFDUJPO UIF BQQMJBODF NVTU CF DPOOFDUFE UP UIF QPXFS TVQQMZ 5IJT MJBCJMJUZ HVBSBOUFF JT WBMJE GPS UIF TFSWJDF MJGF PG UIF