deutsch de Installation and Operation Guide Crystalline Solar Modules Bosch Solar Module c-Si M 60 IN30125 en Operating instructions Issue 01/2013 Bosch Solar Module c-Si M 48 I Bosch Solar Module c-Si M60 I Bosch Solar Module c-Si M60 S I Bosch Solar Module c-Si P60 Robert Bosch GmbH
| Table of Contents I Introduction en Table of Contents en Disclaimer of liability I General information | 3 2 Disclaimer of liability the Module Data Sheet provided with this product. Determine local permits, installation and inspection requirements before installing module(s).
Provide suitable guards to prevent contact with 30 VDC or greater. As a Precaution use properly insu- en 4 Genaral safety 4. Under normal conditions, a photovoltaic module is module. Do not use the junction box to hold or transport the module. Do not drop module or allow objects to fall on module. Do not stand or step on the module. Do not disassemble, modify or adapt the module or remove any part or labeling installed by the manufacturer.
6 | Installation en en Installation | 7 1660 ± 2 l/4 english 1000 375 8x Module mounting holes 830 l/2 l/7 l mounting holes l/7 267,5 l/4 990 ± 2 2x Mounting holes for grounding cable Ø5 18,5 size: 8 x 12 mm Figure 1: Mounting area, vertical 18 l/7 l/7 l mounting holes Figure 3: reverse side Bosch Solar Module c-Si M 60 IN30125 l/4 l/2 l/4 Figure 2: Mounting area, horizontal Bosch Solar Module c-Si M 60 IN30125 Bosch Solar Energy AG Bosch Solar Module c-Si M 60 I
8 | Grounding | Maintenance and upkeep | Disposal Clearance between the module frame and the mounting surface is required to allow cooling air to circu- The installation place should be less than 1,000 m (3,280ft) above sea level. only if the wind pressure load for a module is less any condensation or moisture to dissipate. The mod- than 2,400N/m2 (50PSF). Peak / Rated Power (Pmax, Wp) 225 The salt damage is heavy at the installation place. Max Power Voltage (Vmp, V) 29.
10 | Wiring | Grounding several modules on a support structure with associ- 8 Grounding en Diodes | Maintenance | 11 9 Diodes away by periodic rainfall, but in some instances some maintenance is recommended to clean the surface of the glass with water and a soft cloth or sponge. A ated wiring. Use copper wire that is sunlight resistant and is insulated to withstand the maximum possible system open circuit voltage.
de Bosch Limited Hosur Road, Adugodi Bangalore 560 030 Indien Tel.: + 91 80 6657 1600 Mobil: + 91 97 4149 6854 www.bosch-solarenergy.