Installation Instructions

D371B/D371C | Installation Instructions | 2.0 Installation
.
Bosch | 2/06 | 33852C 5
2.4 Mounting the Catch Plate to the
Door
2.4.1 Direct Mounting
To avoid misaligning the electromagnet
during this procedure, center the catch
plate on the D371B/D371C.
Refer to Figure 7 when installing the catch plate to
the door.
Figure 7: Catch Plate to Door Installation
2
1
6
4
3
5
9
8
7
1 - Bracket
2 - D371B/D371C
Electromagnet
3 - Catch plate
4 - Mounting template
5 - Alignment template
6 - Swivel base
7 - Door
8 - Conduit
9 - Floor
1. Apply power to the D371B/D371C
Electromagnet (Item 2).
2. Attach the catch plate (Item 3) to the
electromagnet.
3. Separate the mounting template (Item 4) from
the alignment template (Item 5).
4. Remove the adhesive backing from the
mounting template and slide the template over
the swivel base (Item 6) with the printing toward
the electromagnet.
5. Gently close the door against the swivel base
and adjust the base flush against the door
(Item 7).
6. While holding the door in position, slide the
mounting template back over the base to lie flat
against the door. Then press the mounting
template, firmly attaching it to the door.
7. Open the door and place the alignment template
inside the mounting template.
8. Rotate the alignment template for horizontal and
vertical alignment.
9. While holding the alignment template in
position, remove the adhesive backing from the
tab. Then press the tab against the door,
attaching the alignment template.
10. Center punch the two points for horizontal and
vertical alignment.
11. Drill two 1/8 in. holes 1 in. to 1.5 in. deep.
Do not drill through the door.
12. Remove the alignment template.
13. Place the swivel base inside the mounting
template, aligning the holes in the swivel base
with the holes in the door.
14. Insert the screws and tighten.
15. Remove the mounting template.