Installation Instructions

D371B/D371C | Installation Instructions | 3.0 Accessories
6 Bosch | 2/06 | 33852C
2.4.2 Through-Door Mounting
Refer to Figure 8 when mounting the catch plate
through the door.
Figure 8: Through-Door Catch Plate Mounting
1
2
3
4
1 - Door
2 - Receiving plate
3 - Swivel base
4 - 3/16 in. machine screws
(2)
1. Repeat Steps 1 through 10 in Section 2.4 Mounting
the Catch Plate to the Door on page 5.
2. Drill two 1/8 in. pilot holes through the door
(Item 1).
3. Drill the pilot holes again using a 5/16 in.
drill.
4. Place the receiving plate (Item 2) in the drilled
holes on the opposite side of the door.
5. Remove the alignment template.
6. Place the swivel base (Item 3) inside the
mounting template, aligning the swivel base
holes with the door holes.
7. Using two 3/16 in. machine screws (Item 4),
attach and tighten the swivel base to the door.
8. Remove the mounting template.
3.0 Accessories
Refer to Table 2 for the D371B/D371C accessories.
Table 2: Accessories
Model Description
D371B 24 V/110 V Magnetic Door Holder, Brass
D371C 24 V/110 V Magnetic Door Holder, Chrome
D372B Surface-mount Backbox, Brass
D372C Surface-mount Backbox, Chrome
D373B 1 in. (2.5 cm) Extension Rod, Brass
(package of 5)
D373C 1 in. (2.5 cm) Extension Rod, Chrome
(package of 5)
D374B 1.5 in. (3.8 cm) Extension Rod, Brass
(package of 5)
D374C 1.5 in. (3.8 cm) Extension Rod, Chrome
(package of 5)
D375B 2 in. (5 cm) Extension Rod, Brass
(package of 5)
D375C 2 in. (5 cm) Extension Rod, Chrome
(package of 5)
D376B 3 in. (7.6 cm) Extension Rod, Brass
(package of 5)
D376C 3 in. (7.6 cm) Extension Rod, Chrome
(package of 5)
D377B 4 in. (10 cm) Extension Rod, Brass
(package of 5)
D377C 4 in. (10 cm) Extension Rod, Chrome
(package of 5)
D378 Extension Rod Wrench
D379 Swivel Base M-16 Drill Fixture