Installation Guide

D7032 Eight-Zone LED Annunciator Expander

Installation Guide

1.0 Notice

These instructions cover the installation of the D7032 Eight-Zone LED Annunicator Expander in a fire system

supervised by a D7024 Fire Alarm Control Panel (FACP).

Install, test and maintain the D7032 according to these instructions, NFPA 72, Local Codes and the Authority Having

Jurisdiction (AHJ). Failure to follow these instructions may result in failure of the device to operate properly. Bosch

Security Systems, Inc. is not responsible for improperly installed, tested or maintained devices.

These instructions contain procedures to follow in order to avoid personal injury and damage to equipment.

2.0 Device Description

The D7032 is an eight-zone LED Annunciator expansion module for use with the D7030X Series LED Annunciators.

Note: For proper operation of the D7030X LED Annunciator with the D7024 FACP, make sure that the panel firmware is

version 2.0 or greater.

Front Outside View

To ANN-MAIN

Remote LED Pin

1-9

Inside View

Figure 1: D7032 Eight-Zone LED Annunciator Expander

3.0 Installing the D7032

Note: Make sure all wiring is un-powered before routing. Annunciator wiring cannot be shared within the same cable with

multiplex, telephone or notification appliance wiring.

Use the supplied cable to connect the D7032 to the D7030X. See Figure 2 for details.

D7030X

D7032

Install Cable

Figure 2: Connecting the D7032 to the D7030X

Note: The D7032 must be mounted within 20 ft. (6 m), and in the same room as the D7030X LED Annunciator. All wiring must

be in conduit.

PAGE 1
D7032 Eight-Zone LED Annunciator Expander Installation Guide 1.0 Notice These instructions cover the installation of the D7032 Eight-Zone LED Annunicator Expander in a fire system supervised by a D7024 Fire Alarm Control Panel (FACP). Install, test and maintain the D7032 according to these instructions, NFPA 72, Local Codes and the Authority Having Jurisdiction (AHJ). Failure to follow these instructions may result in failure of the device to operate properly. Bosch Security Systems, Inc.
PAGE 2
Set the LED jumpers on the D7030X as shown in Figure 3 for operation with the D7032. Note: Set jumpers for 16 LEDs ENABLED and 16 ZONES. D7030X 16 LED 8 LED 16 LED ENABLE TO CTRL-X 16 LED ENABLE Jumper setting for 16 LEDs ENABLED 16 LED 8 LED Jumper setting for 16 ZONES Figure 3: Jumper Settings 4.0 Adding Remote LEDs External LEDs for remote indication of the individual zones may be added by connecting to the remote LED pins as shown in Figure 4.