Installation Guide

Mounting Skirt D9002
Installation Instructions
The D9002 Accessory Module Mounting Skirt can be used to mount
up to six 3x5 modules in a D8103, D8108A or D8109 enclosure.
Before mounting the D9002 in a D8103, D8108A or D8109
enclosure:
1. Mount the 3-hole accessory module(s) to the D9002.
Do not tighten the screws but do make sure they are
secure enough to stabilize the module.
2. Mount the D9002 inside the enclosure: Remove the
tape from the #6x1/4 in. screw in the mounting tab on
the D9002. The screw passes through the mounting
tab and into the skirt mounting hole in the enclosure.
Tighten the screw to secure the D9002 Mounting Skirt
in the enclosure.
Note: The top two mounting locations can only be used if there
are no modules mounted to the top of the enclosure.
D9002 Mounting Skirt (Top)
D9002 Mounting Skirt - Rear View
Mounting Skirt
hook
Mounting Skirt
hook
Lock down tab
Skirt mounting hole