Use and Care Manual

ManualsBrandsBosch ManualsKitchenMiter Finder Digital Angle Finder

2 609 140 572 | (10.6.08) Bosch Power Tools

14 |

– Always observe all of your saw’s

instructions, including those for

positioning and clamping the

workpiece. In some cases, it may

not be possible to set the re-

quired angles on a particular

saw or type of saw, and an alter-

native means of performing the

cut will need to be used. For ex-

tremely acute (sharp) angles, it

may be necessary to make the

cut using a taper jig with a table

saw or circular saw.

Determining Angles for

Compound Miter Cuts

The Miterfinder™ can be used to

easily determine the miter and

bevel angles needed to create pre-

cision joints at compound angles.

This is particularly useful when cut-

ting crown molding laid flat on a

compound miter saw.

Procedure

1) Set the Spring Angle

The spring angle is the angle be-

tween the back of the crown mold-

ing and the wall.

There are two ways to set the

spring angle:

A) Open The Tool to The Spring

Angle

– Open the legs to crown mold-

ing’s spring angle (typically 38°

or 45°).*

Ceiling

Ceiling

Spring

Angle

Spring

Angle

Wall

Wall

daf220_bu_2609140572_001.fm Seite 14 Dienstag, 10. Juni 2008 9:28 09