Use and Care Manual

2 609 140 572 | (10.6.08) Bosch Power Tools
18 |
– Always observe all of your saw’s
instructions, including those for
positioning and clamping the
workpiece. In some cases, it may
not be possible to set the re-
quired angles on a particular
saw or type of saw, and an alter-
native means of performing the
cut will need to be used. For ex-
tremely acute (sharp) angles, it
may be necessary to make the
cut using a taper jig with a table
saw or circular saw.
How to Determine The Spring
Angle of A Crown Molding
1 Place the crown molding on the
Miterfinder™ as shown in Figure.
Note that the back of the crown
molding must be placed on the
top of the tool’s main leg 6 and
that the lower edge of the crown
molding must face the adjustable
leg 2.
2 Open the adjustable leg to the
angle that exactly matches the
lower edge of the crown mold-
ing.
3 Subtract displayed angle mea-
surement from 180° to deter-
mine the spring angle.
Notes:
– The lower edge is typically the
more-detailed edge of the crown
molding.
– The most common crown mold-
ing spring angles are 38° and 45°.
daf220_bu_2609140572_001.fm Seite 18 Dienstag, 10. Juni 2008 9:28 09