Read and Save These Installation Please Read Must Instructions Compmy With Entire ]:nstructions atomLocam Codes Before Proceeding f f Safety WARNING Warning TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Turn off power circuit at service panel and lock out panel before wiring this appliance. A. With internal blower: :[20V AC, 60Hz. :[5A Branch Circuit. B. C. Use this unit only in the manner intended by the manufacturer.
General Znformation !. For the most efficient air flow exhaust, use a straight run or as few elbows as possible. 2. Do not use flex ducting. 3. COLD WEATHER installations should have an additional Blower Cord Connector Connector Access Panel backdraft damper installed to minimize backward cold air flow and a nonmetallic thermal break to minimize conduction of outside temperatures as part of the ductwork. The damper should be on the cold air side of the thermal break.
. nstall are :[5 3/4" from the center line (See Figure 5). Transition For i_ternai bJower installation, install the 7" transition (included) to connect to 7" ducting. If 7" ducting is not available, 8" ducting may be used. In this instance, an additional 7=8" transition must also be used (not included). 4, Place the hood. 5, Tighten the screws, For remote blewer applications, 10" ducting is required. In this instance, a 7"=:[0" transition must also be used.
6. Connect Accessories Wiring f WARMING: Use only spring type wire nuts (included) to make electrical connections. Replacement wire nuts must be rated for a minimum of (2) #!8ga wires and a maximum of 4 #!4ga wires, UL A CSA rated to 600V and 3020 Fi !500 C. Request #189692 when ordering from BSH. For Internal Blower The following accessories are available from your Bosch dealer or through Bosch Service: 800-944-2904. Please reference the model number when requesting these items.
555! McFadden Avenue, Huntington Beach, CA 92649 • 800/944-2904 5060008728 Rev. A (ECO# 5V0iMD) © BSH Home Appliances Corporation 2003 • Litho U. S. A.