Extractor hood DFO060W50 [en] Instruction manual
Ú Table of contents e[nuoIrs]ctimanul Important safety information.....................................................4 Environmental protection ..........................................................5 Saving energy......................................................................................5 Environmentally-friendly disposal.....................................................5 Operating mode..........................................................................5 Exhaust air mode ........
Important safety information Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners. The appliance can only be used safely if it is correctly installed according to the safety instructions. The installer is responsible for ensuring that the appliance works perfectly at its installation location.
Causes of damage Caution! Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage. Always replace faulty bulbs to prevent the remaining bulbs from overloading. Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth. Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only.
Operating the appliance Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes. Filter drawer Controls You can now access the controls and the appliance is ready for operation. Use the toggle switches to set and adjust the various different functions of your appliance. Pulling out the filter drawer Hold the filter pull-out in the middle and pull it out.
Area Cleaning agent Stainless steel Hot soapy water: Clean with a dish cloth and then dry with a soft cloth. Clean stainless steel surfaces in the grind direction only. Special stainless steel cleaning products are available from our after-sales service or from specialist retailers. Apply a very thin layer of the cleaning product with a soft cloth. Painted surfaces Hot soapy water: Clean using a damp dish cloth and dry with a soft cloth/towel. Do not use any stainless steel cleaners.
Trouble shooting Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service. Fault table : Risk of electric shock! Problem Incorrect repairs are dangerous. Repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians. If the appliance is defective, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service. The lighting does not work.
Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.