Extractor hood [en] Instructions for installation and use
en Table of contents INSTRUCTION MANUAL.......................................................... 2 s no i t c u r t s n I ] ne [ rof 8 Intended use................................................................... 2 ( Important safety information ........................................ 2 7 Environmental protection ............................................. 4 Ç Operating modes ........................................................... 5 1 Operating the appliance....................................
Important safety information Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room airdependent heat-producing appliance is being operated. Room air-dependent heat-producing appliances (e.g. gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e.g. a chimney).
en Environmental protection : Warning Risk of electric shock! ■ A defective appliance may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box. Contact the after-sales service. Risk of electric shock!are dangerous. Repairs ■ Incorrect repairs may only be carried out and damaged power cables replaced by one of our trained after-sales technicians.
Operating modes en ÇOperating modes Control panel Exhaust air mode sedom gn i t arepO The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Note: The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms which contain heat-producing appliances.
en Cleaning and maintenance Fan run-on time If you slide in the filter pull-out, the run-on time will be activated for as long as the extractor hood is operating. After approx. 10 minutes, the fan switches off automatically. Lighting The lighting can be switched on and off independently of the ventilation. Press the A button. 2Cleaning and maintenance : Warning ecnane t n i am dna gn i nae lC Risk of burns! The appliance will become hot during operation, especially near the bulbs.
Trouble shooting In the dishwasher: Note: If the metal mesh grease filters are cleaned in the dishwasher, slight discolouration may occur. This has no effect on the function of the metal mesh grease filters. ■ ■ en On appliances with a glass plate in the filter pull-out: ■ ■ The glass plate can be removed easily and can be cleaned in the dishwasher. To remove it, carefully lift the glass plate. Do not clean heavily soiled metal mesh grease filters together with utensils.
en Customer service Replacing bulbs These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. : Warning Risk of burns! Halogen bulbs become very hot when switched on. There is still a risk of burning for some time after they have been switched off. Allow the halogen bulbs to cool down before replacing them. : Warning Risk of electric shock! When changing the bulbs, the bulb socket contacts are live.
Customer service en INSTALLATION INSTRUCTIONS Installation instructions These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. ■ ■ ■ Appliance width 60 cm: This appliance is installed in a upper cabinet. Follow the enclosed installation instructions for additional special accessories (e.g. for circulating-air mode). The surfaces of the appliance are sensitive. Avoid damaging them during installation.
en Important safety information (Important safety information Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners. The appliance can only be used safely if it is correctly installed according to the safety instructions. The installer is responsible for ensuring that the appliance works perfectly at its installation location.
General information : Warning Risk of fire! Grease deposits in the grease filter may catch fire. The specified safety distances must be observed in order to prevent an accumulation of heat. Observe the specifications for your cooking appliance. If gas and electric hobs are operated together, the largest specified distance applies. Only one side of the appliance may be installed directly next to a high-sided unit or a wall.
General information en Electrical connection : Warning Risk of electric shock! Components inside the appliance may have sharp edges. These may damage the connecting cable. Do not kink or pinch the connecting cable during installation. The required connection data can be found on the rating plate inside the appliance; to do this, remove the metal mesh grease filter. Length of the cable: approx. 1.30 m This appliance complies with the EC interference suppression regulations. 1.
Installation Body wall thickness: 16 mm 1. Screw the mounting pieces to the body on the left and right. ¨ 2. Remove the tabs from the bottom of the mounting pieces. © en 2. Connect the power cord provided to the appliance.¨ 3. Use the strain relief to secure the power cord in place.© $ $ PP % % [ Body wall thickness: 19 mm 1. Fold out the tabs on both of the mounting pieces. ¨ 2. Screw the mounting pieces to the body on the left and right. © 3.
Installation en 4. Screw in the filler strip fully. Sliding out the appliance Note: Before you remove the appliance, protect the hob with a piece of polystyrene from the packaging. 1. Use a flat-blade screwdriver to push in the fastening bolt, and turn it 90° until it locks into place. ¨ 2. Push in the fastening bolt gently with your fingers, and turn it until it comes out of the housing along with the spring.
Installation Appliance width 90 cm: You must also screw the appliance to the wall-hanging cupboards either side of it. en Connecting the pipes Note: If an aluminium pipe is used, smooth the area where it is to be connected before you connect it. Exhaust air pipe, dia. 150 mm (recommended size) Fit the exhaust air pipe directly to the air-pipe connector and seal the joint. Exhaust air pipe, dia. 120 mm 1. Fit the reducing connector directly to the air-pipe connector. 2.
Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.