DHE 635... / DHE 645... en Operating and Installation instructions Internet: http://www.bosch-hausgeraete.de Bosch Info-Team: de Tel. 01 80/5 30 40 50 (E 0,12/Min.
GAZ ELECTR. min. 650 2 min. 650 min. 470 min.
Instructions for Use Appliance description Operating modes If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. filter screen door lighting/fan switches alighting Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration.
Before using for the first time Important notes: ❑ The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. ❑ This extractor hood complies with all relevant safety regulations. ❑ Repairs should be carried out by qualified technicians only. Improper repairs may put the user at considerable risk.
Using the extractor hood Kitchen vapour is most effectively eliminated by: Light ❑ Switching on the extractor hood when you start cooking. ❑ Switching off the extractor hood a few minutes after you have finished cooking. Fan speed 1 Light Switching on the fan: ❑ Open the door. ❑ Select fan speed. Switching off the fan: ❑ Close the door. ❑ When the door is opened out again the fan operates at its last speed setting. 2 Fan speed Switching on the fan: ❑ Open the door. ❑ Select fan speed.
Filters and maintenance Different grease filters can be used to absorb the grease particles in kitchen vapour. Fleece grease filter: Metal grease filters: The filter mat consists of highly flameresistant material. The filter mats consist of non-flammable metal. Attention: A build up of greasy residue increases flammability, and the function of the extractor hood may be impaired. Attention: A build up of greasy residue increases flammability, and the function of the extractor hood may be impaired.
Filters and maintenance Removal the grease filter: 1. Open door as far as it will go. 2. Push the filter screen up slightly, lift it towards you over the brackets and take it out downwards.. Fitting grease filters: 1. Clamp in the filter mats with the wire grid. 2. Position the filter screen against the housing and push upwards. Push in the lower edge over the lugs and lower the grid into place. 3. Remove the wire grid. 1. 4.
Filters and maintenance Activated carbon filter: For binding odours in recirculating air mode. Fitting and removal: 1. Open door to the stop. 2. Push the filter screen up slightly, lift it towards you over the brackets and take it out downwards. 5. Insert activated carbon filter in the lower left corner of the housing. Shift it until both hooks slot into the holes and then secure in place with the wing nut. 2. 3.
Cleaning and care Changing the bulbs Isolate the extractor hood by pulling out the mains plug or switching off the fuse. 1. Switch off the extractor hood and deenergize by pulling out the mains plug or switching off the fuse. 2. Press the edges of the lamp cover together where indicated and lift it out towards you. ❑ When cleaning the grease filters, remove grease deposits from accessible parts of the housing.
Installation instructions Important information Before installation 몇 Old appliances are not worthless Optimum efficiency of the extractor hood: rubbish. Valuable raw materials can be reclaimed by recycling old appliances. Before disposing of your old appliance, render it unusable. 몇 You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable.
Before installation Exhaust-air mode 120 150 The exhaust air is discharged upwards through a ventilation shaft or directly through the outside wall into the open. Exhaust air must not be discharged via a smoke or exhaust gas flue which is already in use or via a shaft which is used for ventilating rooms in which fireplaces are located. Discharge exhaust air in accordance with official and statutory regulations (e.g. national building regulations).
Before installation With exhaust mode, a backwash valve should be installed unless it is already incorporated in the exhaust pipe or wall box. If a backwash valve is not included with your appliance, your dealer can supply you with one (see accessories). Connecting to Ø150 mm exhaustair duct Attach the enlarging adapter (enclosed or available from specialist dealer) to the air outlet. Attach the exhaust-air duct to the adapter.
Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the power cord are colourcoded as follows: Green and Yellow Blue Brown – Earth – Neutral – Live If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. Proceed as follows: 1. Connect the green and yellow (Earth) wire to the terminal in the plug marked ‘E’ or with the symbol ( ), or coloured green or green and yellow. 2.
Installation The extractor hood can also be installed slightly lower, depending on the height of the wall cupboards. Position the template correspondingly lower. Observe the minimum distance from hob to extractor hood of 650 mm (the fixing screws must be fitted at least 1040 mm above the hob). 3. Predrill (with bradawl or 2 mm bit) and screw in the screws to 5 mm. Important: If the door of the unit is at a distance from the body of the unit (e.g.
Installation 2. Mark the fixing points on the door. For dimensions of vertical screw fixings, see: 5. The two screws to the right and left inside the housing can be used to adjust door gliding according to the weight of the door. 41 250 + 285 285 570 + 2 If the top edge of the door is not flush with the top edge of the cabinet, amend the dimensions accordingly. If the tops of the cabinets are not installed flush with each other, the door must be mounted correspondingly higher.
DHZ2100 DHZ6201 DSZ11AF 086244 088208 DHZ6501 9000 022729 Robert Bosch Hausgeräte GmbH Printed in Germany 1006 Hi.
