DIVAR IP 6000 (2U) DIP-6180-00N | DIP-6183-4HD | DIP-6183-8HD | DIP-6184-4HD | DIP-6184-8HD en Quick Installation Guide
DIVAR IP 6000 (2U) Table of contents | en 3 Table of contents 1 Safety information 4 1.1 Safety message explanation 4 1.2 Safety precautions 4 1.3 Important safety instructions 5 1.4 Electrical safety precautions 7 1.5 ESD precautions 8 1.6 Operating precautions 8 1.7 Notices 8 1.8 FCC and ICES compliance 9 2 About this manual 11 3 System overview 12 4 Rack installation 14 4.1 Unpacking the system 14 4.2 Preparing for setup 14 4.2.
en | Safety information 1 DIVAR IP 6000 (2U) Safety information Observe the safety notes in this chapter. 1.1 Safety message explanation Warning! ! Indicates a hazardous situation which, if not avoided, could result in death or serious injury. Caution! ! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. Notice! Indicates a situation which, if not avoided, could result in damage to the equipment or environment, or data loss. 1.
DIVAR IP 6000 (2U) Safety information | en 5 Warning! Interruption of mains supply: ! Voltage is applied as soon as the mains plug is inserted into the mains socket. However, for devices with a mains switch, the device is only ready for operation when the mains switch (ON/OFF) is in the ON position. When the mains plug is pulled out of the socket, the supply of power to the device is completely interrupted.
en | Safety information – DIVAR IP 6000 (2U) Do not install device near any heat sources such as radiators, heaters, stoves, or other equipment (including amplifiers) that produce heat. – Never spill liquid of any kind on the device. – Take precautions to protect the device from power and lightning surges. – Unless qualified, do not attempt to service a damaged device yourself. Refer all servicing to qualified service personnel.
DIVAR IP 6000 (2U) Safety information | en – 7 Disconnect the power before moving the unit. Move the unit with care. Excessive force or shock may damage the unit and the hard disk drives. – All the input/output ports are Safety Extra Low Voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits. – If safe operation of the unit cannot be ensured, remove it from service and secure it to prevent unauthorized operation.
en | Safety information DIVAR IP 6000 (2U) Caution! ! 1.5 DVD-ROM Laser: To prevent direct exposure to the laser beam and hazardous radiation exposure, do not open the enclosure or use the unit in any unconventional way. ESD precautions Notice! Electrostatic Discharge (ESD) can damage electronic components. To prevent damage to your system, it is important to handle the electronic components very carefully.
DIVAR IP 6000 (2U) Safety information | en 9 Notice! Video loss is inherent to digital video recording; therefore, Bosch Security Systems cannot be held liable for any damage that results from missing video information. To minimize the risk of losing information, we recommend multiple, redundant recording systems, and a procedure to back up all analog and digital information. Disposal Your Bosch product has been developed and manufactured using highquality materials and components that can be reused.
en | Safety information DIVAR IP 6000 (2U) not installed and used in accordance with the manufacturer’s instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case you will be required to correct the interference at your own expense. 2016.
DIVAR IP 6000 (2U) 2 About this manual | en 11 About this manual This manual is written for professional system integrators and PC technicians. It provides information for the installation and use of the chassis. Installation and maintenance should be performed by experienced and qualified technicians only. Bosch Sicherheitssysteme GmbH Quick Installation Guide 2016.
en | System overview 3 DIVAR IP 6000 (2U) System overview There are several LEDs on the front and rear of the chassis. The LEDs show the over-all status of the system and the activity and health of specific components. Front view: 1 3 2 4 5 6 1 2x USB 2.
DIVAR IP 6000 (2U) System overview | en 5 4 USB ports 6 (2x USB 2.0 and 2x USB 3.0) 13 2x network ports for data transmission (teamed) Note: Do not change the teaming mode! 7 Bosch Sicherheitssysteme GmbH 1x VGA display output Quick Installation Guide 2016.
en | Rack installation DIVAR IP 6000 (2U) 4 Rack installation 4.1 Unpacking the system You should inspect the box the chassis was shipped in and note if it was damaged in any way. If the chassis itself shows damage, file a damage claim with the carrier who delivered it and notify the respective Bosch RMA desk. Due to the weight of the system: After opening the top of the shipping box, one person should stand at either end and lift the disk array out together. Be sure to read the safety precautions.
DIVAR IP 6000 (2U) 4.2.3 Rack installation | en 15 General system precautions – Review the electrical and general safety precautions that came with the components you are adding to your chassis. – Determine the placement of each component in the rack before installing the rails. – Install the heaviest components on the bottom of the rack first, and then work up.
en | Rack installation DIVAR IP 6000 (2U) – an inner fixed chassis rail that secures directly to the chassis – an outer fixed rack rail that secures directly to the rack itself. To separate the inner and outer rails: 4.3.2 1. Locate the rail assembly in the chassis packaging. 2. Extend the rail assembly by pulling it outward. 3. Press the quick-release tab. 4. Separate the inner rail extension from the outer rail assembly.
DIVAR IP 6000 (2U) Rack installation | en 17 3 1 2 To install the inner rails: 1. Place the inner rail extensions on the side of the chassis aligning the hooks of the chassis with the rail extension holes. Make sure the extension faces "outward" just like the preattached inner rail. 4.3.3 2. Slide the extension toward the front of the chassis. 3. Secure the chassis with 2 screws as illustrated. 4. Repeat steps 1-3 for the other inner rail extension.
en | Rack installation 4.3.4 DIVAR IP 6000 (2U) Installing the chassis in the rack Warning! ! Stability hazard Before sliding the unit out for servicing make sure that the rack stabilizing mechanism is in place, or the rack is bolted to the floor. Failure to stabilize the rack can cause the rack to tip over. Warning! ! Do not pick up the unit with the front handles. The handles are designed to pull the system from a rack only.
DIVAR IP 6000 (2U) Rack installation | en 19 Warning! ! Stability hazard Before sliding the unit out for servicing make sure that the rack stabilizing mechanism is in place, or the rack is bolted to the floor. Failure to stabilize the rack can cause the rack to tip over. Warning! ! Do not pick up the unit with the front handles. The handles are designed to pull the system from a rack only.
en | System Setup – first Steps DIVAR IP 6000 (2U) 5 System Setup – first Steps 5.1 Introduction The DIVAR IP 6000 systems are based on Windows Storage Server 2012 R2 operating system. Windows Storage Server 2012 R2 systems provide a user interface for initial server configuration, unified storage appliance management, simplified setup and storage management, and support for Microsoft iSCSI Software Target. It is specially tuned to provide optimal performance for network-attached storage.
DIVAR IP 6000 (2U) System Setup – first Steps | en 21 IP Helper tool The IP Helper tool is available for download as follows: – in the online catalog on the DIVAR IP 6000 product page – under http://mydivar.com – under http://downloadstore.boschsecurity.com/ To start the IP Helper tool: 1. Double-click iphelper.exe. 2. A dialog box opens that displays all IP devices with their IP addresses located in the network. Search for the devices whose network settings you want change. 3. 5.
en | Additional software and documentation 6 DIVAR IP 6000 (2U) Additional software and documentation Software for configuration of hardware and software is available on the online product catalogue. Documentation and software for Bosch Security Systems products can be found in the online product catalogue as follows: 4 Open any browser > enter www.boschsecurity.
DIVAR IP 6000 (2U) 7 OSS licenses | en 23 OSS licenses This chapter provides an overview on used Open Source Licenses in DIVAR IP 6000. The license packages are either used completely or only some parts within a package are used. 7.1 MIT - iniparser component: iniparser url: https://github.com/ndevilla/iniparser/ type: MIT Copyright (c) 2000-2011 by Nicolas Devillard.
en | OSS licenses DIVAR IP 6000 (2U) (A) Copyright Grant - Subject to the terms of this license, including the license conditions and limitations in section 3, each contributor grants you a non-exclusive, worldwide, royalty-free copyright license to reproduce its contribution, prepare derivative works of its contribution, and distribute its contribution or any derivative works that you create.
DIVAR IP 6000 (2U) 8 Service and repair | en 25 Service and repair The storage system is backed by a 3-year warranty. Issues will be handled according to Bosch Service and Support guidelines. The storage equipment is shipped with an original manufacturer Service and Support agreement. Bosch RMA Desk is the Single Point of Contact in case of failure but the Service and Support obligations are fulfilled by the manufacturer or a partner.
Bosch Sicherheitssysteme GmbH Robert-Bosch-Ring 5 85630 Grasbrunn Germany www.boschsecurity.
