Installation Manual

DIVAR IP 6000 (2U) Table of contents | en 3
Bosch Sicherheitssysteme GmbH Installation Manual 2016.08 | V2.1 | DOC
Table of contents
1
Safety information 5
1.1 Safety message explanation 5
1.2 Safety precautions 5
1.3 Important safety instructions 6
1.4 Electrical safety precautions 8
1.5 ESD precautions 9
1.6 Operating precautions 9
1.7 Notices 9
1.8 FCC and ICES compliance 10
2
About this manual 12
3
System overview 13
3.1 Chassis features 13
3.2 Chassis components 13
3.2.1 Chassis 13
3.2.2 Fans 13
3.2.3 Power supply 13
3.2.4 Air shroud 13
3.2.5 Mounting rails 13
3.3 System interface 14
3.3.1 Control panel buttons 15
3.3.2 Control panel LEDs 15
3.3.3 Drive carrier LEDs 16
4
Rack installation 17
4.1 Unpacking the system 17
4.2 Preparing for setup 17
4.2.1 Choosing a setup location 17
4.2.2 Rack precautions 17
4.2.3 General system precautions 18
4.2.4 Rack mounting considerations 18
4.3 Rack mounting instructions 18
4.3.1 Separating the sections of the rack rails 18
4.3.2 Installing the inner rails on the chassis 19
4.3.3 Installing the outer rails to the rack 20
4.3.4 Installing the chassis in the rack 21
4.3.5 Installing the chassis in a Telco rack 21
4.4 Turning on the system 22
5
System Setup – first Steps 23
5.1 Introduction 23
5.2 Setup instruction 23
5.3 Setting the IP address 23
5.4 Standard system configuration 24
6
RAID setup 25
6.1 RAID setup using Remote Desktop Connection 25
6.2 RAID setup using RAID BIOS 26
7
Recovering the unit 27
8
Additional software and documentation 28
9
OSS licenses 29
9.1 MIT - iniparser 29