Installation Manual
Table Of Contents
- Table of contents
- 1 Safety information
- 2 About this manual
- 3 System overview
- 4 Rack installation
- 5 System Setup – first Steps
- 6 RAID setup
- 7 Recovering the unit
- 8 Additional software and documentation
- 9 OSS licenses
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Installing a SATA hard drive
- 10.5 Identifying a faulty SSD drive
- 10.6 Installing a SSD hard drive into a rear drive bay
- 10.7 Replacing the DVD ROM drive
- 10.8 Replacing the front port panel
- 10.9 Installing the motherboard
- 10.10 Installing the air shroud
- 10.11 Replacing a system fan
- 10.12 Replacing the power supply
- 10.13 Monitoring the system
- 10.14 Installing Video Recording Manager locally
- 10.15 Service and repair
- Leere Seite
- Leere Seite
- Leere Seite
38 en | Maintenance DIVAR IP 6000 (2U)
2016.08 | V2.1 | DOC Installation Manual Bosch Sicherheitssysteme GmbH
1 2
1 DVD-ROM 2 Front port panel
To replace the front port panel:
1. Turn off and unplug the unit.
2. Remove the chassis cover.
3. Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
4. Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
5. Insert the new front port panel unit in the slot until the tab locks into place.
6. Connect the data and power cables to the backplane and motherboard.
10.9 Installing the motherboard
Motherboard problems will be handled by trained support people only.
10.10 Installing the air shroud
The air shroud does not require screws for its installation.
Notice!
If a 16 DIMM (13.68" x 13") motherboard is used, it is necessary to use the optional
MCP-310-82502-0N air shroud.
To install the air shroud:
1. Make sure that your air shroud matches your chassis model.
2. Turn off the system and remove the cover.
3. Place the air shroud in the chassis. The air shroud fits behind the two fans closest to the
power supply.