Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 About this manual
- 3 System overview
- 4 Preparing for installation
- 5 Rack installation
- 6 Installing a SATA hard drive
- 7 Turning on the system
- 8 System setup
- 9 Troubleshooting
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Identifying a faulty SSD drive
- 10.5 Installing a SSD hard drive into a rear drive bay
- 10.6 Replacing the DVD ROM drive
- 10.7 Replacing the fron port panel
- 10.8 Installing the motherboard
- 10.9 Installing the air shroud
- 10.10 Replacing a system fan
- 10.11 Replacing the power supply
- 10.12 Replacing the power distributor
- 10.13 Service and repair
- 11 Additional information
DIVAR IP all-in-one 7000 2U Safety | en 11
Bosch Security Systems B.V.
Installation manual
2020.11 | V1.1 | DOC
– Physical access to the system shall be restricted to authorized personnel only. It is
strongly suggested to place the system in an access control protected area, in order to
avoid physical manipulation of the system.
– Windows online update functionality or the corresponding monthly roll-up patches for
offline installation can be used to install OS security updates.
– Limiting local network access to trusted devices is strongly suggested. Details are
described in the Technical note Network Authentication 802.1X and in the Bosch IP Video
and Data Security Guidebook, available in the online product catalog.
– For access via public networks only use the secure (encrypted) communication channels.