Installation Manual

16 en | System overview DIVAR IP all-in-one 7000 2U
2020.11 | V1.1 | DOC
Installation manual
Bosch Security Systems B.V.
LED Description
HDD
This LED indicates activity on the HDDs or peripheral drives when flashing.
Power
This LED indicates that power is being supplied to the system's power supply
units.
This LED should normally be illuminated when the system is operating.
3.4 Hard drive carrier LEDs
The chassis supports hot-swappable SAS/SATA hard drives in hard drive carriers. Each hard
drive carrier has two LEDs on the front of the carrier: one activity LED and one status LED.
Note: For non-RAID configurations, some LED indications are not supported, for example hot
spare.
LED color LED state Description
Activity LED Blue Solid On Hard drive is installed.
Blue Blinking I/O activity.
Status LED Red Solid On Failed hard drive with RSTe
support.
Red Blinking at 1Hz Rebuild hard drive with RSTe
support.
Red Blinking with two
blinks and one stop
at 1Hz
Hot spare for hard drive with
RSTe support.
Red On for five seconds,
then off
Power on for hard drive with
RSTe support.
Red Blinking at 4Hz Identify hard drive with RSTe
support.
3.5 Power supply LEDs
On the rear of the power supply module, an LED displays the status.
LED color LED state Description
Green Solid On Power supply is on.
Amber Solid On The power supply is plugged in and turned off
or
The system is off but in an abnormal state.
Blinking The system power supply temperature has
reached 63°C.
The system will automatically turn off when the
power supply temperature reaches 70°C and
restart when the power supply temperature goes
below 60°C.