Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 About this manual
- 3 System overview
- 4 Preparing for installation
- 5 Rack installation
- 6 Installing a SATA hard drive
- 7 Turning on the system
- 8 System setup
- 9 Troubleshooting
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Identifying a faulty SSD drive
- 10.5 Installing a SSD hard drive into a rear drive bay
- 10.6 Replacing the DVD ROM drive
- 10.7 Replacing the fron port panel
- 10.8 Installing the motherboard
- 10.9 Installing the air shroud
- 10.10 Replacing a system fan
- 10.11 Replacing the power supply
- 10.12 Replacing the power distributor
- 10.13 Service and repair
- 11 Additional information
DIVAR IP all-in-one 7000 2U Installing a SATA hard drive | en 25
Bosch Security Systems B.V.
Installation manual
2020.11 | V1.1 | DOC
6.3 Installing a hard drive carrier into a front drive bay
To install a hard drive carrier into a hard drive bay:
1. Insert the hard drive carrier horizontally into the hard drive bay, orienting the hard drive
carrier so that the release button is on the right.
2. Push the hard drive carrier into the bay until the handle retracts and the hard drive clicks
into the locked position.