Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 About this manual
- 3 System overview
- 4 Preparing for installation
- 5 Rack installation
- 6 Installing a SATA hard drive
- 7 Turning on the system
- 8 System setup
- 9 Troubleshooting
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Identifying a faulty SSD drive
- 10.5 Installing a SSD hard drive into a rear drive bay
- 10.6 Replacing the DVD ROM drive
- 10.7 Replacing the fron port panel
- 10.8 Installing the motherboard
- 10.9 Installing the air shroud
- 10.10 Replacing a system fan
- 10.11 Replacing the power supply
- 10.12 Replacing the power distributor
- 10.13 Service and repair
- 11 Additional information
DIVAR IP all-in-one 7000 2U System setup | en 27
Bosch Security Systems B.V.
Installation manual
2020.11 | V1.1 | DOC
8 System setup
The DIVARIPall-in-one7000 systems are based on the operating system Microsoft Windows
Server IoT 2019 for Storage Standard. The operating system provides an user interface for
initial server configuration, unified storage appliance management, simplified setup and
storage management, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. The
Microsoft Windows Server IoT 2019 for Storage Standard operating system provides
significant enhancements in storage management scenarios, as well as integration of storage
appliance management components and functionality.
i
Notice!
This chapter is valid for DIVARIPall-in-one7000 models that come with pre-installed hard
drives.
The operating system of empty units loaded with third party hard drives will start normally,
but the added hard drives must be configured with the RAID utility prior to initial software
setup.
Refer to
– Configuring hard drives using the RAID setup, page 28
8.1 Default settings
DIVARIP systems are shipped with a pre-installed Configuration Wizard from factory.
All DIVARIP systems are preconfigured with a default IP address and with default iSCSI
settings:
– IP Address: automatically assigned by DHCP (fallback IP address: 192.168.0.200).
– Subnet mask: automatically assigned by DHCP (fallback subnet mask: 255.255.255.0).
Default user settings for administrator account
– User: BVRAdmin
– Password: to be set at first logon.
8.2 Prerequisites
Observe the following:
– DIVARIP needs to have an active network link during installation. Make sure that the
network switch you are connecting to is powered on.
– The default IP address must not be occupied by any other device in the network. Make
sure that the default IP addresses of existing DIVARIP systems in the network are
changed before adding another DIVARIP.
8.3 Operating modes
Operating modes
The DIVARIPall-in-one systems can operate in three different modes:
– Full video recording and management system, utilizing the BVMS and VRM core
components and services: This mode allows for advanced video management features
such as event and alarm handling.
– Pure video recording system, utilizing the VRM core components and services.
– iSCSI storage expansion for a BVMS or VRM system, which runs on a different hardware.