Installation Manual

DIVAR IP all-in-one 7000 2U Table of contents | en 3
Bosch Security Systems B.V.
Installation manual
2020.11 | V1.1 | DOC
Table of contents
1
Safety 5
1.1 Safety message explanation 5
1.2 General safety precautions 5
1.3 Electrical safety precautions 8
1.4 ESD precautions 9
1.5 Operating precautions 9
1.6 Notices 9
1.7 FCC and ICES compliance 10
1.8 Data security precautions 10
2
About this manual 12
3
System overview 13
3.1 Chassis components 13
3.2 Device views 13
3.3 Control panel elements 15
3.4 Hard drive carrier LEDs 16
3.5 Power supply LEDs 16
4
Preparing for installation 17
4.1 Choosing the installation location 17
4.2 Rack precautions 17
4.3 General system precautions 17
4.4 Installation considerations 18
5
Rack installation 19
5.1 Separating the sections of the rack rails 19
5.2 Installing the inner rails on the chassis 20
5.3 Installing the outer rails to the rack 20
5.4 Installing the chassis in the rack 21
6
Installing a SATA hard drive 23
6.1 Removing a hard drive carrier from a hard drive bay 23
6.2 Installing a hard drive into a hard drive carrier 23
6.3 Installing a hard drive carrier into a front drive bay 25
7
Turning on the system 26
8
System setup 27
8.1 Default settings 27
8.2 Prerequisites 27
8.3 Operating modes 27
8.4 Preparing hard drives for video recording 28
8.4.1 Configuring hard drives using the RAID setup 28
8.4.2 Recovering the unit 28
9
Troubleshooting 30
9.1 Overheating 30
10
Maintenance 31
10.1 Replacement components 31
10.2 Removing power from the system 31
10.3 Removing the chassis cover 31
10.4 Identifying a faulty SSD drive 32
10.5 Installing a SSD hard drive into a rear drive bay 33
10.5.1 Removing a hard drive carrier from a rear hard drive bay 33
10.5.2 Installing a hard drive into a rear hard drive carrier 33