Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 About this manual
- 3 System overview
- 4 Preparing for installation
- 5 Rack installation
- 6 Installing a SATA hard drive
- 7 Turning on the system
- 8 System setup
- 9 Troubleshooting
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Identifying a faulty SSD drive
- 10.5 Installing a SSD hard drive into a rear drive bay
- 10.6 Replacing the DVD ROM drive
- 10.7 Replacing the fron port panel
- 10.8 Installing the motherboard
- 10.9 Installing the air shroud
- 10.10 Replacing a system fan
- 10.11 Replacing the power supply
- 10.12 Replacing the power distributor
- 10.13 Service and repair
- 11 Additional information
30 en | Troubleshooting DIVAR IP all-in-one 7000 2U
2020.11 | V1.1 | DOC
Installation manual
Bosch Security Systems B.V.
9 Troubleshooting
9.1 Overheating
Problem Solution
An overheating condition has occurred.
The system status LED is continuously
on.
– Make sure that no cables obstruct the
airflow in the system.
– Make sure that all fans are present and
operating normally.
– Make sure that the chassis covers are
installed.
– Make sure that the heat sinks are
installed properly.
– Make sure that the ambient room
temperature is not too high.