Installation Manual
Table Of Contents
- Table of contents
- 1 Safety
- 2 About this manual
- 3 System overview
- 4 Preparing for installation
- 5 Rack installation
- 6 Installing a SATA hard drive
- 7 Turning on the system
- 8 System setup
- 9 Troubleshooting
- 10 Maintenance
- 10.1 Replacement components
- 10.2 Removing power from the system
- 10.3 Removing the chassis cover
- 10.4 Identifying a faulty SSD drive
- 10.5 Installing a SSD hard drive into a rear drive bay
- 10.6 Replacing the DVD ROM drive
- 10.7 Replacing the fron port panel
- 10.8 Installing the motherboard
- 10.9 Installing the air shroud
- 10.10 Replacing a system fan
- 10.11 Replacing the power supply
- 10.12 Replacing the power distributor
- 10.13 Service and repair
- 11 Additional information
DIVAR IP all-in-one 7000 2U Maintenance | en 31
Bosch Security Systems B.V.
Installation manual
2020.11 | V1.1 | DOC
10 Maintenance
This chapter covers the steps required to install components and perform maintenance on the
chassis.
i
Notice!
Installation should only be carried out by qualified customer service personnel in accordance
with the applicable electrical regulations.
!
Caution!
Review the warnings and precautions listed in the manual before setting up or servicing this
chassis.
10.1 Replacement components
Although not frequently, you may need replacement parts for your system. To ensure the
highest level of professional service and technical support, you must register the systems
according to the instructions available as part of the shipment as well as online from the
Bosch product catalog.
10.2 Removing power from the system
Before performing some setup or maintenance tasks, use the following procedure to ensure
that power has been removed from the system.
To remove the power:
1. Shut down the system.
2. Remove the power cords from the power supplies.
3. Disconnect the cord from the power strip or wall outlet.
10.3 Removing the chassis cover