Quick Start Guide

A series of scripts perform important setup tasks. This can
take several minutes. Do not turn off the computer.
A page is displayed where you can perform initial Windows
configuration tasks.
Note: In case of password loss a system recovery must be
performed as described in the installation manual. The
configuration must be done from scratch or must be
imported.
10. Click the Set time zone, Configure networking and Provide
computer name and domain link, enter the appropriate
information, then click Close. Windows restarts.
11. Press CTR+ALT+DELETE. The Windows logon page is
displayed.
12. Enter the password.
The Welcome page of the Configuration Wizard is
displayed.
13. Configure the system using the Configuration Wizard. To do
this, go through the wizard and follow the instructions on
the screen.
See also:
– Using Configuration Wizard, page 17
– Additional documentation and client software, page 27
Using Configuration Wizard
Intended use for Configuration Wizard is the quick and easy
configuration of a smaller system. Configuration Wizard helps
you to achieve a configured system including VRM, iSCSI
system, cameras, recording profiles and user groups.
User groups and their permissions are configured automatically.
You can add or remove users and set passwords.
Configuration Wizard can access Management Server only on
the local computer.
Configuration Wizard adds the local VRM automatically.
To achieve a quick configuration using the Configuration Wizard:
3.4
DIVAR IP 2000 System setup - first steps | en 17
Bosch Sicherheitssysteme GmbH 2013.09 | V4 | DOC