Operating Manual
Metros digitales Laser DLR130K Bosch manual ingles www.viaindustrial.com
itales Laser DLR130K Bosch manual ingles www.viaindustrial.com
Aim the laser beam at the target surface. Push
the
measuring
button
5
again
to
initiate
the
measurement.
In
the
cont inuous
measu rement
mode,
the
measurement
already
starts
upon
first
actuation of the measuring button
5
.
The
measured
value
appears
after
0.5
to
4
seconds.
The
duration
of
the
measurement
depends
on
the
distance,
the
light
conditions
and
the
reflection
prope rties
of
the
targe t
surface.
The
end
of
the
measurement
is
indicated
by
a
signal
tone.
The
laser
beam
is
switched
off
automatically
upon
completion
of
the measurement.
When
no
measurement
has
taken
place
approx.
20
seconds
after
sighting,
the
laser
beam is switched off automatically to save the
batteries.
Selecting
the
Reference
Point
(see
figures
B–C)
For measuring, it is possible to select from two
different reference points:
• The
rear
edge
of
the
Distance
M easurer
(e.g.,
when
placing
the
Distance
Measurer
flush against a wall),
• The
front
edge
of
the
Di stance
M easurer
(e.g., as when measuring from the edge of a
table onward),
MEASURING
MODES
Length
Measurement
For
length
measu rements,
push
butto n
13.
The
indicator
for
length
measurement
appears in the display.
Push
the
measuring
button
5
once for sighting
and
once
m ore
to
take
the measurement.
The
m easured
value
is
indicated at the bottom in
the display.
Area
Measurement
For
area
measurements,
push
button
12.
The
indicator for area measurement
appears in
the display.
Afterwards,
measure
the
length and the width, one
after another, in the same
manner
as
a
length
measurement.
The
laser
beam
remains
switche d
on between both measurements.
Af ter
taking
the
second
measurement,
the
area/surface
is
automatically
calculated
and
displayed.
The
last
individual
measured
value
is indicated at the bottom in the display, while
the final result is shown at the top.
To
select
the
reference
point,
push
button
9
until the required reference point is indicated in
the
display.
Each
time
after
switching
on,
the
rear
edge
of
the
Distance
Measurer
is
preset
as the reference point.
Changing
the
Unit
of
Measure
The unit of measure can be changed any time
for
display
of
the
measured
values,
even
for
already measured or calculated values.
For display of the current
length
measurement
values,
the
units
of
measure
shown
opposite
are available.
Area
and
volume
values
as
well
as
stored
measured
values
can
only be displayed in “ft” or “m”.
To change the unit of measure, push button
2
until a new unit of measure is displayed.
The
unit-of-measure
setting
is
retained
when
switching the Distance Measurer on or off.
-10-