User`s guide

Page 12
Zone Bypass
This chart explains the procedure for bypassing a faulted zone prior to arming the system.
There may be occasions when it is desirable or necessary to temporarily bypass one or more zones prior to arming the system. Bypass com-
mands only work when the control panel is disarmed. For instance, an open window may cause the DS7447 display to read “Not Ready” followed
by the zone number. The DS7443S and DS7445 may have one of its zone LEDs on steady (the DS7443S cannot display zones 7 & 8). Only one
zone may be bypassed each time the command is used.
If more than one zone requires bypassing, repeat the command for each zone to be bypassed.
NOTE: See Force Arming for another method of zone bypassing.
PIN + [Bypass] [X]
(zone number)
Command
Sequence**
What will Happen
Type of Bypassing
Desired
What to Do
Bypass Faulted
Zones
Arm control panel, if
desired, with entered
zone(s) bypassed.
“
Bypass
” will be displayed on the DS7447
followed by the zone number of any
bypassed zones. The DS7443S and
DS7445 will flash the zone LED of any
zone being bypassed (the DS7443S cannot
display zones 7 & 8).
All bypasses will be cleared.
The Status Light will begin to flash
if no other zones are violated.
Individual zone bypasses
will be cleared.
Read Bypassed
Zones
Clear Individual
Bypassed Zone(s)
Clear All Bypasses
PIN + [Bypass] [X]
(zone number)
PIN + [Bypass]
PIN + [Bypass] [*]
** = If in “Residential Mode”, a PIN is not required for these commands.