Installation Manual

DSA E-Series (E2800 12-bay) Table of contents | en 3
Bosch Sicherheitssysteme GmbH Installaton manual 2018.02 | V1 | DOC
Table of contents
1
Safety 5
1.1 Safety message explanation 5
1.2 Safety precautions 5
1.3 Important safety instructions 5
1.4 Warning notices 7
1.5 Caution notices 8
1.6 Notices 8
2
Before you begin 10
2.1 Hardware registration 10
2.2 Additional equipment 10
2.3 Additional documentation 10
3
System overview 11
3.1 Device views 11
3.2 LED description 13
3.2.1 LEDs on the operator display panel 13
3.2.2 LEDs on the controller unit 14
3.2.3 LEDs on the I/O modules 15
3.2.4 LEDs on the drives 16
3.2.5 LEDs on the power-fan canister 17
3.2.6 Seven-segment-display 17
4
Installation 19
4.1 Installing a 2U 12-bay unit 19
4.2 Installing the front bezel and end caps 21
4.3 Setting the unit ID using the ODP button 21
5
Connection 23
5.1 Connecting the expansion units 23
5.2 Connecting the controller unit to the network 24
5.3 Connecting the controller unit to the management hosts 25
5.4 Connecting the units to the power supply 26
5.5 Supported connections 27
6
Turning on/off AC power 30
6.1 Turning on AC power 30
6.2 Turning off AC power 30
7
Configuring the storage system 31
8
Maintenance 32
8.1 Replacing a drive in a 12-bay unit 32
8.1.1 Preparing to replace a drive 33
8.1.2 Removing a drive 33
8.1.3 Installing a drive 34
8.1.4 After replacing a drive 34
8.2 Replacing a power-fan canister 35
8.2.1 Preparing to remove a power-fan canister 36
8.2.2 Removing a power-fan canister 37
8.2.3 Installing a power-fan canister 38
8.2.4 After replacing a power-fan canister 38
8.3 Seven-segment display codes 38
8.3.1 Seven-segment display sequence codes 39
8.3.2 Seven-segment display codes when controller turns on 40