Instruction manual

5
Intensive setting
You can use the Intensive setting for particularly strong odour
and fume generation.
■ Press the + button several times.
■ › is indicated on the display.
The duration is limited. Then the fan is automatically reduced to
a lower setting. You can reduce the setting any time
by pressing the – button.
Switching on fan run-on
■ Press button r.
The fan runs for approx. 9 min at the selected fan setting.
Then the fan switches off automatically.
■ As long as r is lit, the run-on time can be changed. To do
this, press the – or + button.
The current run-on time can be displayed at any time by
pressing the
r button or changed by pressing the –
or + button.
Light
The light can be switched on and off independently of the fan.
Press button
A.
Setting the brightness
Hold down the
A button until the required brightness
is obtained.
Saturation displays
When the metal-mesh grease filters or the activated carbon
filter are saturated, a signal sounds for 4 seconds after the fan
is switched off.
In addition, the following symbol is indicated on the display:
■ Metal-mesh grease filter: #
■ Activated carbon filter: #’
Now, at the latest, the metal-mesh grease filters should be
cleaned or the activated carbon filter changed.
While the saturation displays are flashing, they can be reset.
To do this, press the
# button (model 1) or the – button
(model 2).
Switching over the display for circulating-air mode
For circulating air mode the electronic control display must be
switched over accordingly:
■ The extractor hood must be connected and switched off.
■ Simultaneously press the % and r buttons until #’is lit.
■ Press the button combination % und r to switch
the electronic control display back to exhaust air mode
(display
#).
Acoustic signal
When a button is pressed, an acknowledgement signal sounds.
Switching off the acoustic signal
When the fan is switched off, simultaneously hold down
buttons
% and + for approx. 3 seconds.
An acknowledgement signal sounds.
Switching on the acoustic signal
Repeat the “Switching off the acoustic signal” process.
Installing and removing filter
ã=Risk of burns, risk of electric shock!
from appliance. Always leave appliance to cool down before
cleaning or servicing. Switch off fuse or pull out mains plug.
Removing metal-mesh grease filter
1. Open lock and fold down the metal-mesh grease filter.
In doing so, place other hand under the metal-mesh grease
filter.
2. Take metal-mesh grease filter out of the holder.
With edge extraction
1. Pull metal-mesh grease filter downwards.
In doing so, place other hand under the metal-mesh grease
filter.
2. Take metal-mesh grease filter out of the holder.
Notes
■ Grease can accumulate in the bottom of the metal-mesh
grease filter.
– Do not hold metal-mesh grease filter at an angle, otherwise
grease will drip out.
Installing metal-mesh grease filter
1. Insert metal-mesh grease filter.
In doing so, place other hand under the metal-mesh grease
filter.
2. Fold up metal-mesh grease filter and lock.