Installation guide

Conettix DX4020 | Installation Guide | 6.0 IP Address Programming
12 Bosch Security Systems, Inc. | 1/09 | F01U045288-05
If you press [Enter] within 5 sec. of seeing the
“Press Enter to go into Setup Mode” message, the
following screen appears.
12. Press [0] then [Enter] to set up the basic Server
configuration.
If the DX4020 was previously programmed with
an IP address, it appears in parentheses. For
example, if the DX4020 was originally
programmed to IP address 172.30.3.36, change it
to 190.200.128.219.
13. Press [1][9][0][.][2][0][0][.][1][2 [8][.][2][1][9][Enter]
to program IP Address 190.200.128.219.
14. When using DHCP, press [0][.][0][.][0][.][0][Enter].
15. When prompted to set the Gateway address:
- If the Gateway address is not required or if
using DHCP, type N and press [Enter].
- If the Gateway address is required, type Y and
the Gateway IP address 190.200.128.1. Then
press [Enter].
The Gateway IP is required only when using
a WAN. In a LAN, the Gateway IP is
generally not required.
The following message appears.
16. If the Netmask requires changing from the default,
enter the number of bits that corresponds to the
Netmask your network is using (Table 5). Press
[Enter] when using DHCP.
See your network administrator for more
information.