Installation manual

User Manual

Record/Playback Tours

Two independent macros (series of commands) can be recorded;

A & B. These macros can be several hours in duration, although

tours involving constant commands only last minutes. While

recording, the on-screen display indicates remaining memory (see

FIGURE 5). To begin recording on A, move the camera to the

desired starting point and type ON-100-ENTER. The AutoDome

now records all camera activities, until the recording is ended by

OFF-100-ENTER. Once A has been recorded, B is available via the

ON/OFF-101-ENTER command. Playback can be continuous

(ON-50-ENTER for A; ON-52-ENTER for B) or one shot

(ON-51-ENTER for A; ON-53-ENTER for B).

Figure 5 Recording

Changing AutoPan and AutoScan speeds

The AutoPan and AutoScan speeds (see FIGURE 6) can be

adjusted via ON-14-ENTER. Use the joystick to adjust the speed.

It is helpful for the Pan or Scan to be active when entering

ADJUST mode, to see the speed change.

Figure 6 AutoPan / AutoScan speed adjust