Installation manual

Roof preparations

6 720 613 057 (2006/04)

5.2 Fitting additional roof battens

When laying the facing panels and collectors in place,

there will have to be additional roof battens of equal

height to those already on the building.

Length of additional roof battens

The minimum length of the additional battens (Fig. 9,

Item 2 is the width of the collector array (Table 5,

page17, dim. A) plus approx. 10 cm for the side clips

(Fig. 9, Item 1).

USER NOTE

As an alternative to additional roof bat-

tens, those already present around the

collector array area can be adjusted to the

same dimensions as the additional roof

battens.

These instructions describe installation

using additional roof battens.

CAUTION!

BUILDING DAMAGE

from leaks in the roof.

B Fasten batten butt joints to the joist

or ensure that they are adequately se-

cure, e.g. by fastening them to the al-

ready existing roof battens (Fig. 9,

Item 3 and Fig. 13, Item 2).

Fig. 9 Length of additional roof battens (here: first lower roof batten with anti-slip protection)

Item 1: Clip

Item 2: Additional roof battens

Item 3: Joining the additional roof battens

63043973.01-1.SD

> 80 mm