Installation manual

Installing the facing panels

6 720 613 057 (2006/04)

B Lay the left-hand facing panel (Fig. 45, Item 2) on the

previous one, and fit in the same way as the right-

hand one (Fig. 42).

B Fasten the panels with screws (12 mm long, Fig. 46,

Pos. 1) and sealing discs in the centre punch marked

on the panel.

B Remove protective film from the adhesive on the fac-

ing panels.

B Press the upper facing panel down onto the lower

one (Fig. 46, Item 3).

B Remove protective film from the back of the flashing.

B Carefully adjust flashing in the area in front of the roof

tile contour (Fig. 46, Item 2).

Fig. 44 Positioning the middle facing panels for landscape

collectors

63043975.42-1.SD

80 - 100 mm 80 - 100 mm

USER NOTE

For two landscape collectors, facing pan-

els are necessary underneath in the mid-

dle (Fig. 44, Item 1). They must overlap

by 80–100 mm.

Fig. 45 Fitting the left-hand lower facing panel

63043975.12-1.SD

USER NOTE

Do not remove protective film from the ad-

hesive on the facing panels (Fig. 45,

Item 1) until all panels are screwed on.

Fig. 46 Fastening the lower panels

63043975.11-1.SD