User manual

16 en | All functions at a glance Panel Controller
F.01U.076.969 | 6.0 | 2010.04 Operation guide Bosch Sicherheitssysteme GmbH
3.5 Configuration
Set input / output groups
– Input group or Output group
– Displaying the assigned elements.
– Add or delete elements.
– Rename group names.
Set groups
– Bypass group, isolate group or walktest group
– Displaying the assigned elements.
– Add or delete elements.
– Rename walktest, bypass and isolate groups.
Detector sensitivity
Change the sensitivity of individual detectors or zones. Two selection options are available: a
default sensitivity and an alternative sensitivity assigned in the FSP-5000-RPS programming
software.
Operator
If the same password is used per access level, the following options are offered:
– Change universal password
The same password can be configured for each access level in the FSP-5000-RPS
programming software. The password for access levels two to four can be changed.
If every user has a different password, the following options are offered:
– Change operator data
Change a user's password.
– Set default password
Reset an operator's password to his/her previous password.
Rename elements
Change the description of the elements.
Overview
Information on valid configuration of the system.
3.6 Switching to day or night mode
– Switch to day or night mode
– In day mode: Set the reset time to night mode for the current day.
Configuration -> Set input / output groups Set groups
Detector sensitivity Operator
Rename elements Overview